Primera Technology RX900 user manual Battery Notice

Page 65

TOC

INDEX

For Users in Canada: This digital apparatus does not exceed the Class B limits for radio noise for digital apparatus set out on the Radio Interference Regulations of the Canadian Department of Communications. Le present appareil numerique n'emet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la class B prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada.

Product Disposal

Do not dispose of the printer or supplies in the same manner as normal house- hold waste. Consult your local authorities for disposal and recycling options.

Battery Notice

This product contains Perchlorate material. Special handling may apply.

For more information, go to http://www.dtsc.ca.gov/hazardouswaste/perchlorate/

CAUTION!

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE EXTERIOR PANELS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. OPERATE THE UNIT WITH ONLY THE PROPER ELECTRICAL SPECIFICA- TIONS AS LABELED ON THE PRINTER AND AC ADAPTER.

CAUTION!

USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION.

CAUTION

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Radiation Exposure Statement

WARNING:

This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and CENELEC limits for exposure to radio frequency (RF) radiation. Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits established for this equipment.

When installing and using this product, a 20-cm passing distance must be main- tained from the body or head of the user or nearby persons and the antenna. The antenna must not be touched during transmitter operation.

Notices and Warnings 61

Page 64 Page 66
Image 65
Page 64 Page 66
Contents 021711-511287 All rights reserved Interactive Feature Table of Contents Page Choosing a Good Location Getting StartedThank YOU… Unpacking and Inspection Identifying the Parts This illustration shows the interior of the printer Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsLeft margin offset Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Setup Using RfidSet Marker Printing and Encoding Other Functions Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Image is Vertically Offset Troubleshooting and MaintenanceSolving Print Alignment Problems Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterAutomatic method Cleaning the PrintheadReplacing the Printhead Manual methodTOC TOC Explanation Interpreting the PRINTER’S Indicator LightsSource Location Technical SupportMedia Types Section Technical SpecificationsPrinting History Battery Notice DPI IndexTOF
Top Page Image Contents