Primera Technology RX900 user manual Using Rfid, Setup

Page 21

TOC

INDEX

Section 3: Using RFID

A: SETUP

RFID Label Stock should have an antenna imbedded between the label adhesive layer and the liner. The antenna should be oriented to the front of the label stock and centered within the label.

Antenna

Label

RFID Chip

Antenna

Follow these instructions each time you load a new roll of RFID Label Stock.

1.Load your RFID label stock according to the instructions printed on the inside cover of your RX900 and found in Section 2B.

2.Before you start printing, adjust the slide bar so the Reader/Writer marker is approximately 1/8" (3mm) left or right from center chip of the antenna. Open the cover of the printer. You will find the slide bar and marker near the front of the printer right behind the tear bar.

Set Marker approxi- mately 1/8" (3mm) left or right from center chip of antenna.

RFID Read/Write Marker

Tear Bar

Slide Bar Handle

Using RFID 17

Image 21

Contents 021711-511287 All rights reserved Interactive Feature Table of Contents Page Getting Started Thank YOU…Choosing a Good Location Unpacking and Inspection Identifying the Parts This illustration shows the interior of the printer Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsLeft margin offset Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Setup Using RfidSet Marker Printing and Encoding Other Functions Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Troubleshooting and Maintenance Solving Print Alignment ProblemsImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterAutomatic method Cleaning the PrintheadReplacing the Printhead Manual methodTOC TOC Explanation Interpreting the PRINTER’S Indicator LightsSource Location Technical SupportMedia Types Section Technical SpecificationsPrinting History Battery Notice DPI IndexTOF