Primera Technology 032910-511262 Inner Diameter, Cartridge Alignment, Center The Print Image

Page 46

TOC

INDEX

Inner Diameter

This value changes the size of the non-printed center. Larger numbers cause the non-printed center to be larger and smaller numbers make the non-printed center smaller. This number is incremented by 0.1mm so a change of 10 for inner diameter changes the diameter by 1mm. Set the diameter to 230 for Primera TuffCoat media.

Cartridge Alignment

The Cartridge Alignment prints a test print and then automati- cally scans the print to configure your printer for bidirectional printing and to align the color and black cartridges for Color+Black printing. It is important to perform this calibration every time you change a cartridge. If you forget to perform this calibration you will be prompted to do so before your first print from the new cartridge.

Center The Print Image

NOTE: Your printer comes from the factory pre-calibrated to print the image in the center of the CD. You can use this adjustment if you need to fine-tune this location.

If you ever wish to verify your factory-calibrated Vertical and Horizontal calibration settings, you can run a simple calibration procedure to assure that your images will be centered when printed on a CD. To do this, refer to the following steps:

1.Verify that a disc and a color ink cartridge are installed in the Publisher. It is important to use the same disc you normally use for your publishing because different brands of discs may vary slightly in size. Also, verify that the Publisher is powered ON and that it is connected to your computer.

2.Click on the Center the Print Image and then the Properties button. The printer will begin printing the calibration test print.

42Creating Discs

Page 45 Page 47
Image 46
Page 45 Page 47
Contents For Macintosh and PC Printing History Table of Contents Interactive Feature Getting Started Thank YOU…TOC Choosing a Good LocationUnpacking and Inspection Identifying the Parts Front Panel and TopRear Panel PC System Requirements Overview of Operation TOC TOC Installing the PC Software SetupInstalling the MAC Software Applying Power Hardware SetupLoading Media Discs TOC Installing the Printer Driver Windows XP Connecting the USB 2.0 Cable/Installing the DriverSelect Install the software If you are using a Mac Installing Ink Cartridges Setup the Kiosk BIN Locating Tabs onCreating Discs Tutorial Copy a Disc Print only for Autoprinter UsersTOC TOC Project Types Using PtpublisherCopy Project Audio Project Data ProjectVideo Project Image Project Add DataAdd Print To Select an exiting labelStart Project Summary Settings Project SummaryProject Options Recording Type Robot Options/Bin Selection Publisher Status Backup Project. PC Disc Publishers Only TOC TOC Rip Audio CD PC Disc Publishers Only TOC Creating a Print Label Using Surething PC Creating a Print Label Using Disc Cover MAC TOC Inspector TOC Advanced Printer Driver Functions PC Print Quality Paper SizeNon-printable Outer Margin Disc Surface QualityColor Matching Ink Saturation Cartridge Alignment Inner DiameterCenter The Print Image Back Change Cartridges Clean/Change Cartridges & Check Ink LevelsClean/Purge DetailsDisc Output Location Enable Bi-di PrintingAdvanced Printer Driver Settings MAC Cartridge to useKiosk Mode Color MatchingConfig Utility Save As DefaultRestore Defaults IntensityClean Cartridge Alignment Calibration Print Change CartridgeImage Centering Disc should look like this Label Design Requirements for Other Graphics Programs Maintenance Cleaning the INK CartridgeInterpreting the PUBLISHER’S Indicators Lights LEDInternal Blue LED Lights Technical Support Source LocationTechnical Specifications Inner Diameter 19, 24, 42 Outer Margin 19, 24, 40Print Quality 11, 20, 40 Reject Area
Top Page Image Contents