Napoleon Fireplaces GD82PT-T, GD82NT-T manual Blower Replacement, Battery Replacement

Your comes equipped with a heat circulating blower. The blower is pre-wired and is controlled by the remote con- trol supplied with the unit. For control details, see operation. Pg. 20.

Drywall dust will penetrate into the blower bearings, caus- ing irreparable damage. Care must be taken to prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from this condi- tion is not covered by the warranty policy.

1.Turn off the power to the fi replace.

2.Turn off the gas valve.

BLOWER

MOUNTING

PLATE

REMOVE 4 SCREWS

FIGURE 41

3.Remove optional front, glass door, bowl w/ rocks, burner, decorative panel, & burner bottom.

4.The blower mounting plate can now be removed. Remove the four screws that secure the plate to the fi rebox base.

5.The blower is secured to the fi rebox. Disconnect the wire connectors before attempting to remove the blower from the fi rebox.

6.Remove the two screws securing the blower and lift through blower access opening.

Note: When re-installing the replacement blower, it will be necessary to replace the gasket (W290-0104) on the blower mounting plate.

FIGURE 42

REMOVE 2 SCREWS

1.Remove the optional front. (In- structions on Pg. 17)

2.Tilt the control panel forward al- lowing access to the electode box which is screwed to the base of the fi rebox. (Fig. 43)

BATTERY REPLACEMENT

FIGURE 43

BURNER

CONTROL PANEL BASE

CONTROL PANEL

SEE-TH

N

D

O

W

BURNER ELECTRODE

BOTTOM BOX

CURVED DECORATIVE PANEL

(AA Battery Required)