20
TIME OUT
If the appliance is turned on and the Receiver does not receive any command for 24 hours, it automatically turns the appliance and the Remote Control off.
FIREPLACE OPERATION
To operate this fi replace using the remote, the pilot must be running and the gas valve turned to the “ON” position. Ensure that the receiver has power and the backup switch is in the auto position.
FIGURE 39
1.Install the batteries (AAA) into the remote control transmitter. The “HOUSE” icon with room temperature will be displayed.
2.Press the ON/OFF button on the remote. Icons will appear at the same time and acoustic signal is generated if not, move the transmitter closer to the re- ceiver and repeat. If a signal is still not heard, it will be necessary to execute the address setting procedure. Note: There maybe a few seconds delay before the receiver responds. Especially when using the wrought iron face- plate.
3.Fahrenheit - Celsius temperature indicatior
It is possible to set the Remote Control transmitter to display the temperatures in either Fahrenheit or Celsius. Use the UP or DOWN button on the transmitter until the cursor (small triangle) is left of the clock icon.
4.From time 0:00 press the LEFT key ten times. The display will show the transmitter address. Use the RIGHT button to toggle from °F to °C and vice versa. The display will show the selected unit of measue. Press the LEFT button to exit this function.
2.FLAME HEIGHT
This function allows remote control of the fl ame height. Check that the Remote Control is on, otherwise, turn on the Remote Control and wait 5 seconds. Select the manual
flame height until the cursor (small triangle) is to the left of the big fl ame. (Fig. 47) Use the RIGHT or LEFT button to set the desired fl ame height. Six fl ame levels are included, from 1 (minimum) to 6 (maximum). An acoustic signal from the Receiver confi rms the reception of the command.
FIGURE 47
3.AUTOMATIC CHANGE OF FLAME HEIGHT
The system is provided with three automatic sequences to change continuously the fl ame height. Thirty steps compose each sequence with an interval between one step and the other of 5 seconds, for a total duration of 2.5 minutes. At the end the sequence repeats continually until the sequence function is changed to an alternate pattern or turned to off. The Remote Control can select one of the predefi ned se- quences. Use the UP or Down button until the cursor (small triangle) is to the left of the two small fl ames. (Fig. 48)
Use the left or right button to select sequence 1, 2 or 3. When using the sequence function the room thermostat is active.
FIGURE 48
HAND HELD REMOTE OPERATIONS
1.ON / OFF
To turn the fi replace on press the ON / OFF button, the
fireplace will always light at maximum fl ame setting. Press the ON / OFF button again to turn the fi replace off.
4.ROOM THERMOSTAT
The Remote Control can operate as a room thermostat. To activate this function use the UP and DOWN key until the cursor (small triangle) is left of the thermometer icon. Then use the right of left button to set the desired room temperature. (Fig. 49)
This control system will cycle automatically the appliance on or off to maintain the selected temperature.