19
NIGHT LIGHTTM REPLACEMENT
Yo u r
comes equipped with our Night LightTM. The light has been
If in the event the lamp or lens needs to be replaced, follow the instructions below.
GASKET
FIGURE 46
Unplug the wire harness
/transformer from the junction box inside the fi replace or turn off the electrical breaker for the fi replace.
FIGURE 44
LENSE
FRAME
Remove the four screws that secure the lens frame to the top of the fi rebox.
This frame retains the glass lens. The lamp can now be accessed.
LENSE
FRAME
SCREWS
FIREBOX TOP
Note: Do not handle the lamp (bulb) with bare fingers, protect with a clean dry cloth.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp and lens are special “high temperature” products.
When
THE FIREBOX MUST BE SEALED.
Over tightening the screws could break the lens.
“Light Leakage” from the upper area may be observed.
The holes in the lamp housing are necessary for
FIGURE 45
ventilation and must not be blocked.
OPERATION / MAINTENANCE
TIME OUT
If the appliance is turned on and the Receiver does not re- ceive any command for 24 hours, it automatically turns the appliance
FIREPLACE OPERATION
To operate this fi rplace using the remote, the pilot must be running and the gas valve turned to the “ON” position. Ensure that the receiver has power and the backup switch is in the
auto position. | FIGURE 46 | |
|
|
|
|
|
|
1.Install the batteries (AAA) into the remote control transmitter. The “HOUSE” icon with room temperature will be displayed.
2.Press the ON/OFF button on the remote. Icons will appear at the same time and acoustic signal is generated if not, move the transmitter closer to the re- ceiver and repeat. If a signal is still not heard, it will be necessary to execute the address setting procedure. Note: There maybe a few seconds delay before the re- ceiver responds. Especially when using the wrought iron faceplate.
3.Fahrenheit - Celsius temperature indicator
It is possible to set the Remote Control transmitter to dis- play the temperatures in either Fahrenheit or Celsius. Use the UP or DOWN button on the transmitter until the cursor (small triangle) is left of the clock icon.
4.From time 0:00 press the LEFT key ten times. The display will show the transmitter address. Use the RIGHT button to toggle from °F to °C and vice versa. The display will show the selected unit of measure. Press the LEFT button to exit this function.