IBM SC41-5420-04 manual Pvc, None NONE, *REQUEST, *ACCEPT, Lind 15, *LIND, *TRANSMIT

Work with TCP/IP Remote System Information

System: SYSNAM890

Type options, press Enter. 1=Add 4=Remove 5=Display

	Internet	Network		Reverse
Opt	Address	Address	PVC	Charges

________________

(No remote system information)

Figure 9. Work with Remote System (X.25) Information

Type option 1 (Add) at the input-capable top list entry to go to the Add TCP/IP Remote System (ADDTCPRSI) display, as shown in Figure 10.

Add TCP/IP Remote System (ADDTCPRSI)

Type choices, press Enter.
Internet address . . . . . . . . > '9.4.73.66'
Network address . . . . . . . . > 40030002
PVC logical channel identifier			001-FFF
X.25 reverse charge		*NONE	*NONE, *REQUEST, *ACCEPT
	Additional Parameters
Default packet size:
Transmit packet size		*LIND	*LIND, 64, 128, 256, 512...
Receive packet size		*LIND	*LIND, *TRANSMIT, 64, 128...
Default window size:
Transmit window size		*LIND	1-15, *LIND
Receive window size		*LIND	1-15, *LIND, *TRANSMIT
			Bottom
F3=Exit F4=Prompt	F5=Refresh	F12=Cancel	F13=How to use this display
F24=More keys

Figure 10. Add Remote System (X.25) Information

The network controller used by iSeries TCP/IP does not allow you to specify X.25 user facilities. However, some of the values usually configured on a controller, using the ADDTCPRSI command, allow you to configure each X.25 remote system. These values include reverse charging, packet sizes, and window sizes.

Use the following CL command to enter the information as shown in the display above:

ADDTCPRSI INTNETADR('9.4.73.66')

NETADR(40030002)

Notes:

1.Specifying remote system information for an X.25 DDN interface causes that information to be used instead of the DDN conversion algorithm. The DDN conversion algorithm is used only for a connection with DDN specified as *YES when you try to connect to a host that is not defined in the remote system

Chapter 1. Configuring TCP/IP 17