IBM SC41-5420-04 manual Display TCP/IP Route Information

vThe network ID of the interface must be equal to the logical AND of the next hop for the route and the subnet mask for the interface.

Notes:

1.If the next hop of a route is identical to an interface’s IP address, that route will never be bound to another interface.

2.When starting interfaces (if all interfaces are currently inactive) routes are bound to the interfaces with the same best-match-first algorithm. An exception is if the route is defined with a preferred binding interface. In this case, an attempt is made to bind the route to the interface that is indicated. If the binding attempt fails, then the best-match-first algorithm is used.

Display TCP/IP Route Information

The display TCP/IP route information function allows you to view information about TCP/IP routes.

To display TCP/IP route information:

1.On the Work with TCP/IP Network Status menu, type 2 on the command line or enter the WRKTCPSTS *RTE command.

2.Press the Enter key.

The first of the two Display TCP/IP Route Information displays appears, as shown in Figure 27.

Display TCP/IP Route Information

			System: SYSNAM04
Type options, press Enter.
5=Display details
Route	Subnet	Next	Route
Opt Destination	Mask	Hop	Available
9.125.87.0	255.255.255.0	*DIRECT	*YES
9.125.87.0	255.255.255.0	*DIRECT	*YES
9.125.109.3	*HOST	9.125.87.17	*YES
127.0.0.0	255.0.0.0	*DIRECT	*YES
*DFTROUTE	*NONE	9.125.87.169	*YES
*DFTROUTE	*NONE	9.125.87.250	*YES

		Bottom
F3=Exit F5=Refresh	F6=Print list	F11=Display route type F12=Cancel
F13=Sort by column	F17=Top	F18=Bottom

Figure 27. Display TCP/IP Route Information, Display 1 of 2

To view the second display, press F11 (Display route type). The route information is presented as shown in Figure 28 on page 38. To return to the first display, press F11 (Display next hop).

Chapter 2. TCP/IP: Operation, Management, and Advanced Topics 37