IBM SC41-5420-04 manual Working with Configuration Status, Confirm End of TCP/IP Connections

Confirm End of TCP/IP Connections

					System: SYSNAM04
Local internet address		. . . . . . . . . . . :		*ALL
Press Enter to confirm		your choices for 4=End.
Press F12 to return to		change your choices.
	Remote	Remote	Local	Local
Opt	Address	Port	Address	Port	Type
4	9.5.15.134	1024	9.125.87.10	telnet	*TCP

Bottom

F11=Display	connection state F12=Cancel F14=Display port numbers
F22=Display	entire field

Figure 32. Confirm End of TCP/IP Connections

To end the TCP/IP connections, press the Enter key from the Confirm End of TCP/IP Connections display.

If you decide not to end a TCP/IP connection or if you want to change your choices, press F12 (Cancel).

Working with Configuration Status

To work with the line description used by an interface:

1.On the Work with TCP/IP Interface Status menu, type 12 in the option field for each interface that you want to work with.

2.Press the Enter key.

This option issues the WRKCFGSTS (Work with Configuration Status) command for the line description associated with the interface. Using the options shown in Figure 33 on page 42 you can vary a line description on or off, display the Work with Job menu, and display the line description or mode status.

This option cannot be used for IP over SNA interfaces because IP over SNA does not use specific line descriptions.

Chapter 2. TCP/IP: Operation, Management, and Advanced Topics 41