Fujitsu XG2600 manual Rear-Access Configuration Factory Default

Page 33

XG2600 Hardware Guide	Chapter 2 Installation

2.2.2Rear-Access Configuration (Factory Default)

This section describes how to install switch in Rear-Access configuration (Factory Default).

Decide positions for rack mounting brackets

1.Decide positions of rack mounting brackets.

It is possible to install the switch either in a standard front position of the rack or in an offset position of the rack. In case to locate the switch offset from the front side, change the positions of rack mounting brackets.

[STANDARD]

[OFFSET]

Plug into the

hole of the device.

Rack Mounting Clamps

33	Installation of the switch

Image 33

Contents Xxxx-xxxx-xxxx XG2600Preface Contents Connecting a Setup PC Organization and Usage of This Manual About the SymbolsAbout This Manual Target Readers and Required KnowledgeTrademark Notification in This Manual Abbreviated Product NamesProduct name Description in this manual Manual Name Description How the Manuals for This Device Are OrganizedSafety Precautions Symbols DefinitionsAbout Warning Descriptions If you notice abnormal conditions such as Failure to follow this may cause damage to Ensuring Security Precautions for UseSafety CleaningHigh safety Static electricityAbout Our Green Products Laser safetyXG2600 Hardware Guide Chapter Getting Started Items in the Package / Names and Functions Parts ListCD-ROM LED Details Switch Fan Unit SideLED Name Light Status LED Functions/BehaviorsSR/10GBASE-LR Switch Interface SideFDX LED PrecautionsSFP+ LINK/ACT Top Surface Attach Cable Holder to the switch first How to attach Cable Holder Cable Restraints with Tyraps1 SFP+ Module OptionInstall ation Installation Requirements Requirements for Installation EnvironmentTemperature and Humidity Requirements Power RequirementsSpace Requirements Installation RequirementsCheck-list Check Item Check ResultInstallation of the switch Decide Switch Access ConfigurationRear-Access Configuration Factory Default Intake PSU2 Slot PSU1 SlotSlot 1/Slot Side Fan Unit SideFront-Access Configuration User Configured Exhaust AirflowRear-Access Configuration Factory Default Decide positions for rack mounting bracketsDecide positions of rack mounting brackets Fix rack mounting rails to the rack posts Install the switch in a 19 rackM6 Machine Screws Remove rack mounting brackets Change the direction of fans to adjust airflowLoosen two screws to remove fan unit Remove fansChange direction of fans Fix fans Remove screws and take off PSU units on the Interface Side XG2600 Hardware Guide Installation Attach rack mounting brackets to the switch Discharging Twisted Pair Cable Connecting the EquipmentCleaning of SFP+ Module Cleaning SFP+ Module / Optical ConnectorCleaning of Optical Connector Blow dust away with cleanly dry air or nitrogenRemoval of Micro Dust Connecting Twisted Pair Cable Connecting Twisted Pair Cable / SFP+ ModuleConnecting SFP+ Module Replacing SFP+ Module Make the replacing SFP+ slot to the disable statusType Core/Cladding Diameter Cable Length m# online ether port Plugging in the USB Memory Check and confirm that USB port is in a disable statusPlug in the USB Memory Replacing the USB Memory UnplugConnecting a Setup PC Necessary Hardware / SoftwareConnect RS232C Cable # clear logging error Turn on the PowerPrepare a Setup PC Press Return key or Enter key PrecautionsSetup Items Confirm # is shown on screen コマンド Time SettingCommand When connecting through10GBASE-R SFP+ port Set up IP addressFlash LED IndexXG2600 Hardware Guide Index XG2600 Hardware Guide