XG2600 Hardware Guide | Chapter 2 Installation |
|
|
2.3Connecting the Equipment
We recommend discharging static electricity of twisted pair cable before connecting it to the switch. See below for the procedure of discharging. Also see below for how to install USB memory.
2.3.1Discharging Twisted Pair Cable
Discharge static electricity of the twisted pair cable through the ground wire cable (ground wire for power supply, buildings, etc.) using static electricity removal tool, before connecting twisted pair cable to the switch.
There is a product below for the static electricity removal tool.
Maker | : トシシステム株式会社 |
Product Name | : LAN Cable ESD Removal Tool |
Part Number | |
| LAN Cable ESD Removal Tool |
Crocodile clip
Precautions
•Unplug both ends of the twisted pair cable from equipments (HUB, router, and workstation) during discharging operation.
•Do not use ground wire of electronic devices. Use grounded cable for power supply or buildings.
•Do not short circuit with AC power supply when using ground wire for power suppl.
1.Insert one plug of the twisted pair cable to LAN Cable ESD Removal Tool.
The condition of twisted pair cable can be either both ends open or one end open.
2.Connect (contact) crocodile clip of LAN Cable ESD Removal Tool to the ground wire for more than one minute.
3.Remove LAN Cable ESD Removal Tool from twisted pair cable, and connect twisted pair cable to the switch.
4.Continue discharging the twisted pair cable one by one following the process from 1 to 3 above.
Precautions
Quickly connect twisted pair cable to the switch after discharge. Discharge effect will be lost if twisted pair cable is left unconnected to the switch.
42 | Connecting the Equipment |