Fujitsu XG2600 manual Switch Interface Side, SR/10GBASE-LR

XG2600 Hardware Guide Chapter 1 Getting Started

1.1.4Switch Interface Side

PSU Slots for			Serial Port
		SFP+ Slots	Reset Switch
Rear-Access Installation
	Port1		Port25
	Port2		Port26
PSU1	PSU2		USB Port
Power Supply Unit	Power Supply Unit		Management Port
Power Inlet

•PSU Slots for Rear-Access Installation

		PSUs are plugged in the slots when the switch is used in Rear-Access configuration.
•	Power Inlet	Plug the attached Power Cable in the package.
•	Power Supply Unit	This switch is installed with two PSUs.
•	SFP+ Slots	Plug SFP+ modules for connecting Ethernet based networking equipment (10GBASE-
		SR/10GBASE-LR).
		Port number is assigned from the upper side of the leftmost port to the right. For
		example, Port 1 is the upper side of the leftmost port, and Port 26 is the lower side of the
		right most port.
•	Reset Switch	Push to reboot.
•	USB Port	Connect USB memory for backup-copying and restoring configuration files and
		firmware.

•Serial Port (Console Connection)

The Serial Port is used to connect the switch with the console (PC) for setting and command line interface via the attached Console Cable (RJ45 to Serial Adapter) and RS232C crossover cable (D-SUB9) .

Caution

Serial Port is only used for connecting the switch with RS-232C interface of the console. Do not connect other interfaces such as LAN/ISDN which cause an error.

Reference User’s Guide "1.1.5 Console Port Specifications" (pg.28)

• Management Port This is used to connect Ethernet based (10/100BASE-TX) networking equipment. Use

Category-5 LAN cables.

20 Items in the Package / Names and Functions