Using Printer Utilities
CONFIG
Use this tab to control the following printer features:
•Power Save determines the length of time the printer waits after a job is printed before it goes to a reduced power state. If the printer is used frequently, select OFF which keeps the printer ready to print with the minimum
•Econo Mode determines the toner quantity the printer should use when printing. If set to ON, the printer conserves toner when printing. The default value is OFF, which provides 100% usage
•Auto Continue determines what action the printer should take when a manual feed print job is sent to the printer and there is no paper in the MP Tray. If set to ON, the printer will pick up the paper from Tray 1 after ten seconds. Otherwise, the printer will wait for you to load paper in the MP Tray.
•Altitude helps the printer optimize its output depending on the air pressure of the region. If you are close to sea level, it should be set to “Low.” If at a high elevation (1,500 m / 5,000 ft or higher), set it to “High.”
•Jam Recovery determines what action the printer should take when a paper jam occurs. When set to OFF, the printer does not reprint a page that has jammed. When set to ON, the printer keeps the image in memory for a printed page until the printer signals that the page has successfully printed. The printer reprints all jammed pages.