Xerox 490 manual Manipulate the Imported Simplex Imposition File

Xerox 490/980 Color Continuous Feed Printing System Pre-Calibration Engine Density Adjustment

Manipulate the Imported Simplex Imposition File

Now that you have imported the simplex imposition file into the PC-UI, you must ensure that the Logical Paper Settings of the imposition file match whatever paper stock width you are currently using.

1.On the left-side navigation pane of the Xerox 490/980 Color Continuous Feed Printing System PC-UI, select [Resource Management].

2.Select the [System Resource] tab.

3.In the Media/Directory drop-down menu, select [System Directory].

4.Double-click [Simplex_PreCal.forms] to open the imposition file.

Note

For the next step, the Paper Identifier Name should follow the convention of

[Simplex_PreCal_ ] and the number in inches or millimeters of the paper stock width (i.e., [Simplex_PreCal_19-5in], [Simplex_PreCal_495mm]). Decimal points are not allowed in a Paper Identifier Name, so substitute in a dash [ - ] if the paper stock width is not a whole number.

5.Rename the imposition file. Add an [ _ ] to the end the paper stock width in inches or millimeters (i.e. [

of the Paper Identifier Name and type Simplex_PreCal_ [Paper Stock Width]].

6.Select [Properties] located on the bottom of the window.

7.Ensure that the numerical values entered for the Offset Specification and Logical Page Size are correct for your current paper stock width. To do this, reference Appendix A which explains how to find these values. When you are finished, return to this procedure.

8.Select [OK] to save the Logical Page Setting changes (if any were made).

9.Select [OK] again to save the imposition file.

Color Management Guide 4-7