Xerox 490 manual Check for Queue and Imposition Files, Check for Existing Imposition Files

Xerox 490/980 Color Continuous Feed Printing System Prepare for Color Calibration

Check for Queue and Imposition Files

The purpose of this section is to determine if any of the imposition files or queues used in chapter 4 have already been created.

The following procedures explain how to check for pre-existing imposition files and queues.

Check for Existing Imposition Files

A new imposition file is required only if the paper stock is being changed. An imposition file may have already been created to accommodate the new paper stock width. The following procedure explains how to check for existing imposition files.

1.Ensure that the Xerox 490/980 Color Continuous Feed Printing System is powered on and is connected to the PC-UI.

2.Select [Resource Management] on the left-side navigation pane of the PC-UI.

3.Look for any imposition files that are named with the following convention:

• Simplex_PreCal_[Paper Stock Width]

Note

As an example, if you were changing to 18 in (457 mm) width paper stock, you would look for an imposition file called [Simplex_PreCal_18in].

4.If you find an imposition file that has the width of paper stock you are using, you can skip the Set Up Imposition Files section of Chapter 4.

5.If you do not find an imposition file that has the width of paper stock that you are using, you must perform the Set Up Imposition Files section of Chapter 4.

Check for Existing Queues

A new queue is required only if the paper stock width is being changed. A queue may have already been created to accommodate the new paper stock width. The following procedure explains how to check for existing queues.

1.Ensure that the Xerox 490/980 Color Continuous Feed Printing System is powered on and is connected to the PC-UI.

2.Select [Queue Management] on the left-side navigation pane of the PC-UI.

3.Look for any imposition files that are named with the following convention:

• TRC_[Paper Stock Width]

Note

As an example, if you were changing to 19.5 in (495 mm) width paper stock, you would look for a queue called [TRC_19-5in].

4.If you find a queue that has the width of paper stock you are using, you can skip the Create a New Queue section of Chapter 4.

5.If you do not find a queue that has the width of paper stock that you are using, you must perform the Create a New Queue section of Chapter 4.

Color Management Guide 3-11