Xerox 490 manual Pre-Calibration Engine Density Adjustment

Pre-Calibration Engine Density Adjustment Xerox 490/980 Color Continuous Feed Printing System

Note

In order to change color density values, the system must be paused (in NOT READY mode) and the user must be logged in as a System Administrator. Once both of these requirements have been met, the color density values can be changed from the PC-UI by selecting [Printer Management] on the left-side navigation pane.

13.If the 100% color square on the test pattern (on average) is darker in density than the Dark color square on the SIR, lighten (decrease) the print density of that color by 1 using the PC- UI.

14.If the 100% color square on the test pattern (on average) is lighter in density than the Light color square on the SIR, darken (increase) the print density of that color by 1 using the PC-UI.

15.Select [Setting] after making the appropriate color density changes.

16.If another print-out of the test pattern is required, it may be released from the hold queue of the IOT-UI without resubmitting the job from the client station.

Note

In the following step, if any color density settings are at their maximum or minimum values, and the color settings are still not within the specified parameters of the SIR, notify your local Xerox service representive.

17.Repeat steps 8-16 as many times as is required until all four colors are within the specified parameters of the SIR.

18.When you are finished with this procedure, delete the job from the hold queue of the IOT- UI.

4-20 Color Management Guide