Belkin F5D5230-4 manual Step

Page 29

Step 4

2.Select "Static IP Address" and click "Select". The following screen will appear:

3.Enter your static IP address.

4.Enter your Subnet mask.

5.Enter the Gateway address.

6.Once you have filled in all of this information, click "Enter".

27

Image 29

Contents Port Cable/DSL Gateway Router Table of Contents Introduction Integrated 10/100 4-Port SwitchNAT Firewall Security Built-in DhcpSystem Requirements Package ContentsWeb-Based User Interface Product Descriptions Rear Panel WAN Link StatusWall Mounting the Belkin Gateway Router Belkin Docking OptionsBelkin Docking Ring Is my IP address Static or Dynamic? Sharing Your Internet Connection Is Done In 4 Easy StepsStep Does my Internet service provider use PPPoE?Is my connection bound to a MAC address? Does my connection have an assigned host name?My IP Address is User Name Assigned by your ISP Password Service NameStep Write your IP Configuration settings here Connect Your Equipment Basic Parts Required for Each Computer on Your ListNIC Step Configuring Your Computers Using Belkin NetSetup Setup your computers for networkingInstalling the Belkin Soho Networking Software Step Step Step Step Step Step Verify That Your Computers are Networked Step Accessing the Web-Based Setup Utility Configuring Your Router if Your Provider Uses Dynamic Step Step Step Step Configuring Your Router if Your Provider Uses PPPoE Step Click MAC Cloning/Entry. The following screen will appear Security Log DMZ SettingsIntrusion Detection On/Off Virtual Server Settings Special Application Settings Client Filter Settings NAT Enable/Disable Services LAN Dhcp SettingsSet Time Zone Change PasswordRemote Management UtilitiesRestore Defaults ResetUpdate Firmware Problem Possible Cause/Solution TroubleshootingBetween the Gateway Router Make sure your computers Make sure the coaxial cable Glossary of Terms Glossary of Terms Port Cable/DSL Gateway Router F5D5230-4 Product SpecificationsCE Declaration of Conformity Warranty, FCC, CE StatementP73794