Belkin F5D5230-4 Basic Parts Required for Each Computer on Your List, Connect Your Equipment

Page 13

Step 2

STEP 2: Connect your computers to the Belkin 4-Port Cable/DSL Gateway Router (the Router)

In order for you to be able to connect your computers to the Router, each must be equipped with a network interface card (NIC) such as an internal PCI card (for desktop computers), a PC card (for laptop computers), or a USB Ethernet adapter (an alternative for USB-equipped computers only). Each computer connects to the Router via a network cable. You will need one network cable for each PC. The Belkin Gateway Router also connects to your Cable or DSL modem via a network cable. Be sure you have the proper parts before starting. NOTE: Some Cable or DSL modems connect to your computer using USB. Your Cable or DSL modem must have an Ethernet connector on it to connect the Belkin Gateway Router. If your modem does not have an Ethernet connection, you must use a Belkin Switch rather than the Router.

Basic Parts Required for Each Computer on Your List:

2 networking cables * for each computer, one for the Modem-to- Router connection; and one for the PC-to-Router connection.

1 each–Network Interface Card (NIC)—an internal PCI card for each PC and a PC card for each laptop

*We recommend top-quality Belkin CAT6 Networking Cables, part number A3L980-XX-S

Connect Your Equipment

Refer to the diagram below to aid in the connection process.

1.Power down your equipment.

Make sure that you have followed the steps to find your network configuration settings before you begin connecting your equipment. Be sure that the power to the Router, your modem, and all of your PCs has been turned OFF.

11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Port Cable/DSL Gateway Router Table of Contents Introduction Integrated 10/100 4-Port SwitchNAT Firewall Security Built-in DhcpWeb-Based User Interface Package ContentsSystem Requirements Product Descriptions Rear Panel WAN Link StatusBelkin Docking Ring Belkin Docking OptionsWall Mounting the Belkin Gateway Router Is my IP address Static or Dynamic? Sharing Your Internet Connection Is Done In 4 Easy StepsStep Does my Internet service provider use PPPoE?Is my connection bound to a MAC address? Does my connection have an assigned host name?My IP Address is User Name Assigned by your ISP Password Service NameStep Write your IP Configuration settings here Connect Your Equipment Basic Parts Required for Each Computer on Your ListNIC Step Installing the Belkin Soho Networking Software Setup your computers for networkingConfiguring Your Computers Using Belkin NetSetup Step Step Step Step Step Step Verify That Your Computers are Networked Step Accessing the Web-Based Setup Utility Configuring Your Router if Your Provider Uses Dynamic Step Step Step Step Configuring Your Router if Your Provider Uses PPPoE Step Click MAC Cloning/Entry. The following screen will appear Intrusion Detection On/Off DMZ SettingsSecurity Log Virtual Server Settings Special Application Settings Client Filter Settings NAT Enable/Disable Services LAN Dhcp SettingsSet Time Zone Change PasswordRemote Management UtilitiesRestore Defaults ResetUpdate Firmware Problem Possible Cause/Solution TroubleshootingBetween the Gateway Router Make sure your computers Make sure the coaxial cable Glossary of Terms Glossary of Terms Port Cable/DSL Gateway Router F5D5230-4 Product SpecificationsCE Declaration of Conformity Warranty, FCC, CE StatementP73794
Top Page Image Contents