Belkin F5D5230-4 manual WAN Link Status, Rear Panel

Page 6

Product Descriptions

Front Panel

Power LED–When lit, this light indicates that the unit is receiving power

WAN Link Status

GREEN - indicates that there is an active connection with the Cable or DSL modem. If this light is off, the link is not established.

FLASHING GREEN – When the WAN link status light is flashing green, data is flowing between the Router and the Cable or DSL modem.

Port Activity/Status Lights

AMBER-Solid amber indicates that there is a 100Mbps (100Base-TX) link between the Router and the computer connected to that port.

GREEN-Solid green indicates that there is a 10Mbps (10Base-TX) link between the Router and the computer connected to that port.

FLASHING–When a port status light is flashing either amber or green, data is flowing between the Router and the computer connected to that port.

Rear Panel

Power Input Jack–Connect the DC power supply

WAN Port–Connect the network cable from the Cable or DSL modem to the WAN port

LAN Ports–Numbered 1 – 4. Connect the network cable from your PCs to these ports. Note: they do not need to be connected sequentially. For example, in a two-computer network you can connect one computer to Port 4 and another to Port 1.

Reset Button–If the Router stops functioning properly, you can power off and on the Router, without losing your settings. Press and hold the RESET button for 2 seconds. The power light will begin blinking and the port lights may blink. When the lights stop blinking, the Gateway Router has been reset.

4

Image 6
Contents Port Cable/DSL Gateway Router Table of Contents NAT Firewall Security Integrated 10/100 4-Port SwitchIntroduction Built-in DhcpPackage Contents Web-Based User InterfaceSystem Requirements Product Descriptions WAN Link Status Rear PanelBelkin Docking Options Belkin Docking RingWall Mounting the Belkin Gateway Router Sharing Your Internet Connection Is Done In 4 Easy Steps Is my IP address Static or Dynamic?Is my connection bound to a MAC address? Does my Internet service provider use PPPoE?Step Does my connection have an assigned host name?User Name Assigned by your ISP Password Service Name My IP Address isStep Write your IP Configuration settings here Basic Parts Required for Each Computer on Your List Connect Your EquipmentNIC Step Setup your computers for networking Installing the Belkin Soho Networking SoftwareConfiguring Your Computers Using Belkin NetSetup Step Step Step Step Step Step Verify That Your Computers are Networked Step Accessing the Web-Based Setup Utility Configuring Your Router if Your Provider Uses Dynamic Step Step Step Step Configuring Your Router if Your Provider Uses PPPoE Step Click MAC Cloning/Entry. The following screen will appear DMZ Settings Intrusion Detection On/OffSecurity Log Virtual Server Settings Special Application Settings Client Filter Settings Services LAN Dhcp Settings NAT Enable/DisableRemote Management Change PasswordSet Time Zone UtilitiesReset Restore DefaultsUpdate Firmware Troubleshooting Problem Possible Cause/SolutionBetween the Gateway Router Make sure your computers Make sure the coaxial cable Glossary of Terms Glossary of Terms Product Specifications Port Cable/DSL Gateway Router F5D5230-4Warranty, FCC, CE Statement CE Declaration of ConformityP73794