Belkin F5D5230-4 manual Between the Gateway Router

Page 42

Troubleshooting

Problem	Possible Cause/Solution

The WAN link LED is not on or I	1. Check the connection
cannot connect to the Cable or	between the Gateway Router
DSL modem.	and the Cable or DSL modem.
	Make sure the network cable
	from the Cable or DSL modem
	is connected to the port on the
	Router labeled WAN.

	2. Make sure the Cable or
	DSL modem is powered and
	switched on.

	3. Make sure the Router has
	power. The Amber LED on
	the bottom of the front panel
	should be illuminated.

	4. Some Cable or DSL modems
	require a crossover cable.
	Check with the manufacturer
	of your Cable/DSL modem for
	specifics about this.
My connection type is Static IP	Since your connection type is
Address. I cannot connect to	Static IP Address, your ISP must
the Internet.	assign you the IP Address,
	Subnet Mask, and Gateway
	address. Make sure that the
	Router’s connection type is
	configured as "Static IP Address"
	and verify your settings.

40

Image 42

Contents Port Cable/DSL Gateway Router Table of Contents NAT Firewall Security Integrated 10/100 4-Port SwitchIntroduction Built-in DhcpPackage Contents Web-Based User InterfaceSystem Requirements Product Descriptions WAN Link Status Rear PanelBelkin Docking Options Belkin Docking RingWall Mounting the Belkin Gateway Router Sharing Your Internet Connection Is Done In 4 Easy Steps Is my IP address Static or Dynamic?Is my connection bound to a MAC address? Does my Internet service provider use PPPoE?Step Does my connection have an assigned host name?User Name Assigned by your ISP Password Service Name My IP Address isStep Write your IP Configuration settings here Basic Parts Required for Each Computer on Your List Connect Your EquipmentNIC Step Setup your computers for networking Installing the Belkin Soho Networking SoftwareConfiguring Your Computers Using Belkin NetSetup Step Step Step Step Step Step Verify That Your Computers are Networked Step Accessing the Web-Based Setup Utility Configuring Your Router if Your Provider Uses Dynamic Step Step Step Step Configuring Your Router if Your Provider Uses PPPoE Step Click MAC Cloning/Entry. The following screen will appear DMZ Settings Intrusion Detection On/OffSecurity Log Virtual Server Settings Special Application Settings Client Filter Settings Services LAN Dhcp Settings NAT Enable/DisableRemote Management Change PasswordSet Time Zone UtilitiesReset Restore DefaultsUpdate Firmware Troubleshooting Problem Possible Cause/SolutionBetween the Gateway Router Make sure your computers Make sure the coaxial cable Glossary of Terms Glossary of Terms Product Specifications Port Cable/DSL Gateway Router F5D5230-4Warranty, FCC, CE Statement CE Declaration of ConformityP73794