Barco Fusion 4MP manual How to use the controls, To put the display in standby mode

Page 18

Display information

To display the OSD (on-screen display). In the OSD, this button acts as Enter button to make selections.

4.Standby touch key

To put the display in standby mode.

5.Power LED

Indicates the display’s power status.

Green: Display is on (when enabled in the OSD).

Orange: Display is in Standby power-saving mode.

Off: Display is disconnected from the power or the LED’s on state is disabled in the OSD.

Note: When the LED is disabled in the OSD, it will still be activated (green) when the display is on but does not receive any video signal.

How to use the controls

1.When the OSD is not on the screen, touch any of the soft touch keys.

The front illumination is switched on for about 10 seconds.

2.While the illumination is on, touch the Enter touch key to display the main menu. It contains several submenus.

3.To open a submenu, use the Up or Down touch keys to select the submenu. Next, press the Enter touch key to open the submenu.

4.To exit from a submenu, use Up or Down to select EXIT. Next, press Enter .

If you exit from the Main Menu, you exit the OSD.

5.To change an adjustment value or setting, use Up or Down to select the adjustment or setting. Next, press Enter to go

18

Image 18

Contents Nio Fusion 4MP This page intentionally left blank Overview of product documentation Sources of informationUser interface Items in the navigation frameItems in the toolbar frame Graphic board control panel Languages supportedStart Settings Control Panel Display Accessing the Barco tabUsing the Barco tab Barco Driver PropertiesDisplay Information Barco system reportMediCal QAWeb Barco Adapter ConfigurationAdvanced properties for Mxrt controller Display LayoutColor Format Display ResolutionBit TrueColor Mode Bit TrueColor Mode HDR Clone Primary display is cloned to the secondary displayOpenGL and Direct3D Main SettingsCustom Settings Wait for Vertical SyncRotation Device DetailsWait for Vertical Sync OpenGL Profiles Activating a configuration profileModifying the configuration parameters Adding a new application profileConfiguring the Windows desktop Graphic board control panel Use a screen saver to avoid image retention PrecautionsOptimize the lifetime of your display Understand pixel technologyEnhance user comfort Maximize Quality AssuranceFront controls are soft touch keys Display controlsOverview of controls To move down or decrease values in the OSDHow to use the controls To put the display in standby modeStand-by switching To switch from on state to stand-byTouch the Stand-by touch key Info messages On-screen display OSD Complete OSDLuminance and color menu Display Function menu Reading room definition submenu Settings menu Input Switch Mode Select Auto if you wish the display to Concepts Changing Display FunctionsInformation menu InformationDisplay function selection To select a display function DFDicom offset ALC & Dicom OptionsYou can select the following DFs IntroductionTo select a reading room setting You can select the following offsetsUse Enter to confirm the selection You can select the following reading room types To modify a reading room definitionSwitching Dpms on/off To switch Dpms on/offTo disable the user controls Switching Power LED on/offTo switch the power LED on/off Enabling/disabling User ControlsTo enable the user controls again Barco web sites Visit Barco at Visit Medical Imaging atNovember