Barco Fusion 4MP Color Format, Display Resolution, Bit TrueColor Mode Bit TrueColor Mode HDR

Page 9

Graphic board control panel

•Clone

The primary display is cloned to the secondary display.

Color Format

•24-Bit TrueColor Mode

•30-Bit TrueColor Mode (HDR)

Display Resolution

• Sets display resolution for 1 or 2 displays.

Note: To switch out of SingleView or Clone mode, the buttons in this Control Panel page must be used. The main Windows Control Panel cannot be used. Depending on your system, certain configurations can be disabled.

Note: Clone Mode is supported for two color displays or projectors in 32bpp. Clone mode is not supported on grayscale displays. Also, HDR is not supported while in Clone Mode.

When choosing Clone Mode under the Barco Adapter Configuration page, if two displays are enabled, then the larger of the two current resolutions will be used. If only one of the two displays is enabled, the enabled displayís current resolution will be used.

When the resolution set for clone mode is larger then the maximum supported on a display, the resolution set on the Master will automatically be scaled to maximum resolution of the Cloned display. If the Scale to Display Preferred Mode is checked, the maximum resolution will be the EDID preferred mode. If it is unchecked, then it will be the largest mode in the Cloned displays mode list. Clone mode can only be exited through the Barco Adapter Configuration page in the Barco Advanced Control Panel.

Note: Not all options are available at all times. Please select the help tips in the driver software for more information.

9

Image 9

Contents Nio Fusion 4MP This page intentionally left blank User interface Sources of informationOverview of product documentation Items in the navigation frameItems in the toolbar frame Languages supported Graphic board control panelUsing the Barco tab Accessing the Barco tabStart Settings Control Panel Display Barco Driver PropertiesBarco system report Display InformationAdvanced properties for Mxrt controller Barco Adapter ConfigurationMediCal QAWeb Display LayoutBit TrueColor Mode Bit TrueColor Mode HDR Display ResolutionColor Format Clone Primary display is cloned to the secondary displayCustom Settings Main SettingsOpenGL and Direct3D Wait for Vertical SyncRotation Device DetailsWait for Vertical Sync Modifying the configuration parameters Activating a configuration profileOpenGL Profiles Adding a new application profileConfiguring the Windows desktop Graphic board control panel Optimize the lifetime of your display PrecautionsUse a screen saver to avoid image retention Understand pixel technologyMaximize Quality Assurance Enhance user comfortOverview of controls Display controlsFront controls are soft touch keys To move down or decrease values in the OSDTo put the display in standby mode How to use the controlsStand-by switching To switch from on state to stand-byTouch the Stand-by touch key Info messages On-screen display OSD Complete OSDLuminance and color menu Display Function menu Reading room definition submenu Settings menu Input Switch Mode Select Auto if you wish the display to Information menu Changing Display FunctionsConcepts InformationTo select a display function DF Display function selectionYou can select the following DFs ALC & Dicom OptionsDicom offset IntroductionTo select a reading room setting You can select the following offsetsUse Enter to confirm the selection To modify a reading room definition You can select the following reading room typesTo switch Dpms on/off Switching Dpms on/offTo switch the power LED on/off Switching Power LED on/offTo disable the user controls Enabling/disabling User ControlsTo enable the user controls again Visit Barco at Visit Medical Imaging at Barco web sitesNovember