Barco Fusion 4MP manual Info messages

Page 20

Display information

2.A warning message appears. Press the Stand-by touch key again to switch the display into stand-by or press any other key to keep the display in on state.

To switch from stand-by to on state:

1.Touch any of the soft touch keys.

The front illumination is switched on for about 10 seconds.

2.While the illumination is switched on, touch the Stand-by touch key to switch the display on.

Info messages

The following messages may appear automatically on the screen:

Input Selection

The Input selection menu appears in case 2 video signals are connected and the resolution of one or both video signals is too high to display them both.

In that case the input selection menu allows you to select one of both video signals.

No signal selected

This message appears in case the display finds no proper video signal at its inputs.

Resolution too high

This message appears in case the resolution of the selected video signal is too high to display.

Text mode / Diagnostic mode

These messages appear for a few seconds directly after switching to Text mode or Diagnostic mode.

In text mode, the display luminance is approximately half of the luminance in diagnostic mode. Text mode is intended for using the

20

Image 20

Contents Nio Fusion 4MP This page intentionally left blank Sources of information User interfaceOverview of product documentation Items in the navigation frameItems in the toolbar frame Graphic board control panel Languages supportedAccessing the Barco tab Using the Barco tabStart Settings Control Panel Display Barco Driver PropertiesDisplay Information Barco system reportBarco Adapter Configuration Advanced properties for Mxrt controllerMediCal QAWeb Display LayoutDisplay Resolution Bit TrueColor Mode Bit TrueColor Mode HDRColor Format Clone Primary display is cloned to the secondary displayMain Settings Custom SettingsOpenGL and Direct3D Wait for Vertical SyncWait for Vertical Sync RotationDevice Details Activating a configuration profile Modifying the configuration parametersOpenGL Profiles Adding a new application profileConfiguring the Windows desktop Graphic board control panel Precautions Optimize the lifetime of your displayUse a screen saver to avoid image retention Understand pixel technologyEnhance user comfort Maximize Quality AssuranceDisplay controls Overview of controlsFront controls are soft touch keys To move down or decrease values in the OSDHow to use the controls To put the display in standby modeTouch the Stand-by touch key Stand-by switchingTo switch from on state to stand-by Info messages Luminance and color menu On-screen display OSDComplete OSD Display Function menu Reading room definition submenu Settings menu Input Switch Mode Select Auto if you wish the display to Changing Display Functions Information menuConcepts InformationDisplay function selection To select a display function DFALC & Dicom Options You can select the following DFsDicom offset IntroductionUse Enter to confirm the selection To select a reading room settingYou can select the following offsets You can select the following reading room types To modify a reading room definitionSwitching Dpms on/off To switch Dpms on/offSwitching Power LED on/off To switch the power LED on/offTo disable the user controls Enabling/disabling User ControlsTo enable the user controls again Barco web sites Visit Barco at Visit Medical Imaging atNovember