Barco Fusion 4MP manual To enable the user controls again

Page 33

Display information

6.Exit the OSD

Now the user cannot display the OSD again until the user controls keycode is entered (see below).

To enable the user controls again:

1.To enter the user controls keycode, the OSD must not be visible.

2.Touch any of the soft touch keys to switch on the front illumination.

3.While the illumination is on, touch the following keys in successive order:

Enter , Down , Up , Down , Enter .

As a result, the User Controls setting in the Settings menu is switched on again.

33

Image 33

Contents Nio Fusion 4MP This page intentionally left blank User interface Sources of informationOverview of product documentation Items in the navigation frameItems in the toolbar frame Languages supported Graphic board control panelUsing the Barco tab Accessing the Barco tabStart Settings Control Panel Display Barco Driver PropertiesBarco system report Display InformationAdvanced properties for Mxrt controller Barco Adapter ConfigurationMediCal QAWeb Display LayoutBit TrueColor Mode Bit TrueColor Mode HDR Display ResolutionColor Format Clone Primary display is cloned to the secondary displayCustom Settings Main SettingsOpenGL and Direct3D Wait for Vertical SyncRotation Device DetailsWait for Vertical Sync Modifying the configuration parameters Activating a configuration profileOpenGL Profiles Adding a new application profileConfiguring the Windows desktop Graphic board control panel Optimize the lifetime of your display PrecautionsUse a screen saver to avoid image retention Understand pixel technologyMaximize Quality Assurance Enhance user comfortOverview of controls Display controlsFront controls are soft touch keys To move down or decrease values in the OSDTo put the display in standby mode How to use the controlsStand-by switching To switch from on state to stand-byTouch the Stand-by touch key Info messages On-screen display OSD Complete OSDLuminance and color menu Display Function menu Reading room definition submenu Settings menu Input Switch Mode Select Auto if you wish the display to Information menu Changing Display FunctionsConcepts InformationTo select a display function DF Display function selectionYou can select the following DFs ALC & Dicom OptionsDicom offset IntroductionTo select a reading room setting You can select the following offsetsUse Enter to confirm the selection To modify a reading room definition You can select the following reading room typesTo switch Dpms on/off Switching Dpms on/offTo switch the power LED on/off Switching Power LED on/offTo disable the user controls Enabling/disabling User ControlsTo enable the user controls again Visit Barco at Visit Medical Imaging at Barco web sitesNovember