Xantrex Technology Inverter Communications Adapter manual 2Configuration

Page 29

2Configuration

Chapter 2, “Configuration” describes how to install the ICAP software provided with the ICA and how to set up a modem (if used).

The following topics are covered in this chapter.

For this topic...	See...

“Installing the ICA Software: ICAP”	page 14

“To install the software with Autorun enabled	page 14
on your CDROM drive:”

“To start the program from the CD if Autorun	page 19
is disabled on your computer:”

“To start the program from a command	page 20
prompt:”

“Setting Up a Modem Connection”	page 21

Image 29

Contents Inverter Communications Adapter ICA Page Inverter Communications Adapter Date and Revision Organization Purpose Scope AudienceIllustrations Conventions UsedAbbreviations and Acronyms Related Information Important Safety Instructions Viii Contents Warranty and Return Information Figures Xii Tables Xiv 1Installation Introduction Features/Components1Inverter Communications Adapter ICA To install the ICA Connecting the ICA Cable2Connecting Directly to the Inverter To connect a modem to an inverter Connecting the ICA to a Computer using a ModemTo use a modem, the following is required 3Connecting the ICA to a Computer using a Modem To connect multiple adapters to a single serial port Connecting Multiple ICAs to a Single Computer4Connecting Multiple ICAs Positive Ground or PV Ground Fault Protection Installations RJ 11 connector on ICA Adapter Advanced Monitoring Software Additional Possible Requirements2Configuration Starting the Setup Program Using Autorun Installing the ICA Software Icap2ICAP License Agreement Screen 4ICAP Install Folder Screen 6Ready to Install Screen 8Installed Screen Starting Setup Manually To start the program from a command prompt Starting Setup From a Command PromptMake a New Connection Setting Up a Modem ConnectionTo establish the type of modem connection Establish the Type of ConnectionTo enter the COM port values Enter COM Port Property ValuesPage 3Operation 1ICAP Splash Screen Starting IcapOFF Srch on CHG User Interface FeaturesExit Icap Menu BarGo Past END Menu To use the Go Past END Menu featureMultiple-Unit Drop-Down Box LEDs and LCD DisplayNavigation Buttons Keyboard Commands 3Keyboard Commands Terminal Emulation Programs Only Changing Icap Settings 3Identifying the Number of ICAs attached Identifying Single or Multiple ICAsAssigning ID Numbers to the ICA Reset to DefaultsAssigning Customer IDs Optional To change ID Number on the ICA4Assigning ID Numbers to the ICA To make changes to the Advanced Configuration settings Advanced Configuration Settings6Changing the PC’s COM Port Number Changing the PC’s COM Port NumberTroubleshooting the ICA Testing the ICATroubleshooting if No Response comes from the ICA Reset Program Display Anomaly Check Configuration8Screen Display Startup Anomaly #2 Warranty Warranty and Return InformationProduct DisclaimerExclusions Return Material Authorization PolicyOut of Warranty Service Return ProcedureSerial Number Purchased From Purchase Date Information About Your SystemPage Index Index Page Xantrex Technology Inc