Xantrex Technology Inverter Communications Adapter manual LEDs and LCD Display

Page 46

Operation

Communications

This drop-down menu item provides a means to reset the RS232-port used by the ICA and select the number of ICAs attached.

HELP

Access help information by using one of the following methods:

•Click here on the Menu Bar

•Press F1

•Press ALT + H + H

To leave HELP, press ESC.

LEDs and LCD Display

The LEDs and LCD display show inverter status.

Multiple-Unit Drop-Down Box

Directly below the LEDs is the Multiple-unit Drop-down box. Use this drop-down box to select which unit (inverter) to access.

See Figure 3-2, “ICAP User Interface Window” on page 27 for the location of the LEDs, LCD, and Multiple-Unit Drop- down Box.

30	975-0052-01-01 Rev A

Image 46

Contents Inverter Communications Adapter ICA Page Inverter Communications Adapter Date and Revision Purpose Scope Audience OrganizationConventions Used IllustrationsAbbreviations and Acronyms Related Information Important Safety Instructions Viii Contents Warranty and Return Information Figures Xii Tables Xiv 1Installation Features/Components Introduction1Inverter Communications Adapter ICA Connecting the ICA Cable To install the ICA2Connecting Directly to the Inverter To use a modem, the following is required Connecting the ICA to a Computer using a ModemTo connect a modem to an inverter 3Connecting the ICA to a Computer using a Modem Connecting Multiple ICAs to a Single Computer To connect multiple adapters to a single serial port4Connecting Multiple ICAs Positive Ground or PV Ground Fault Protection Installations RJ 11 connector on ICA Adapter Additional Possible Requirements Advanced Monitoring Software2Configuration Installing the ICA Software Icap Starting the Setup Program Using Autorun2ICAP License Agreement Screen 4ICAP Install Folder Screen 6Ready to Install Screen 8Installed Screen Starting Setup Manually Starting Setup From a Command Prompt To start the program from a command promptSetting Up a Modem Connection Make a New ConnectionEstablish the Type of Connection To establish the type of modem connectionEnter COM Port Property Values To enter the COM port valuesPage 3Operation Starting Icap 1ICAP Splash ScreenUser Interface Features OFF Srch on CHGIcap Menu Bar ExitTo use the Go Past END Menu feature Go Past END MenuLEDs and LCD Display Multiple-Unit Drop-Down BoxNavigation Buttons Keyboard Commands 3Keyboard Commands Terminal Emulation Programs Only Changing Icap Settings Identifying Single or Multiple ICAs 3Identifying the Number of ICAs attachedAssigning Customer IDs Optional Reset to DefaultsAssigning ID Numbers to the ICA To change ID Number on the ICA4Assigning ID Numbers to the ICA Advanced Configuration Settings To make changes to the Advanced Configuration settingsChanging the PC’s COM Port Number 6Changing the PC’s COM Port NumberTesting the ICA Troubleshooting the ICATroubleshooting if No Response comes from the ICA Reset Program Check Configuration Display Anomaly8Screen Display Startup Anomaly #2 Warranty and Return Information WarrantyDisclaimer ProductReturn Material Authorization Policy ExclusionsReturn Procedure Out of Warranty ServiceInformation About Your System Serial Number Purchased From Purchase DatePage Index Index Page Xantrex Technology Inc