Xantrex Technology Inverter Communications Adapter manual Navigation Buttons

Page 47

User Interface Features

Navigation Buttons

Use the virtual Navigation Buttons to move around within the Menu Maps. Navigation buttons are grouped into four categories:

•INV or GEN buttons access Inverter or Generator features.

•The Menu Heading buttons access the Menu Headings for each menu map.

•The Menu Item buttons navigate through the menu items associated with each menu heading.

•The (+) or (–) buttons modify system parameters.

Pressing the virtual Navigation Buttons in ICAP will not take the user past the End Menu in each Menu Map like the ICM does.

ICAP Keyboard and Terminal Emulation Keyboard Shortcut Com- mands

The keystrokes listed in the following tables enable navigation through the menus and provide the means to monitor or change available settings using a computer keyboard.

•Table 3-1 lists keystrokes available in both ICAP and when using terminal emulation with the ICA program.

•Table 3-2 lists keystrokes available only in ICAP.

•Table 3-3 lists keystrokes available only when using terminal emulation with the ICA program.

975-0052-01-01 Rev A

31

Image 47

Contents Inverter Communications Adapter ICA Page Inverter Communications Adapter Date and Revision Organization Purpose Scope AudienceIllustrations Conventions UsedAbbreviations and Acronyms Related Information Important Safety Instructions Viii Contents Warranty and Return Information Figures Xii Tables Xiv 1Installation Introduction Features/Components1Inverter Communications Adapter ICA To install the ICA Connecting the ICA Cable2Connecting Directly to the Inverter To connect a modem to an inverter Connecting the ICA to a Computer using a ModemTo use a modem, the following is required 3Connecting the ICA to a Computer using a Modem To connect multiple adapters to a single serial port Connecting Multiple ICAs to a Single Computer4Connecting Multiple ICAs Positive Ground or PV Ground Fault Protection Installations RJ 11 connector on ICA Adapter Advanced Monitoring Software Additional Possible Requirements2Configuration Starting the Setup Program Using Autorun Installing the ICA Software Icap2ICAP License Agreement Screen 4ICAP Install Folder Screen 6Ready to Install Screen 8Installed Screen Starting Setup Manually To start the program from a command prompt Starting Setup From a Command PromptMake a New Connection Setting Up a Modem ConnectionTo establish the type of modem connection Establish the Type of ConnectionTo enter the COM port values Enter COM Port Property ValuesPage 3Operation 1ICAP Splash Screen Starting IcapOFF Srch on CHG User Interface FeaturesExit Icap Menu BarGo Past END Menu To use the Go Past END Menu featureMultiple-Unit Drop-Down Box LEDs and LCD DisplayNavigation Buttons Keyboard Commands 3Keyboard Commands Terminal Emulation Programs Only Changing Icap Settings 3Identifying the Number of ICAs attached Identifying Single or Multiple ICAsTo change ID Number on the ICA Reset to DefaultsAssigning ID Numbers to the ICA Assigning Customer IDs Optional4Assigning ID Numbers to the ICA To make changes to the Advanced Configuration settings Advanced Configuration Settings6Changing the PC’s COM Port Number Changing the PC’s COM Port NumberTroubleshooting the ICA Testing the ICATroubleshooting if No Response comes from the ICA Reset Program Display Anomaly Check Configuration8Screen Display Startup Anomaly #2 Warranty Warranty and Return InformationProduct DisclaimerExclusions Return Material Authorization PolicyOut of Warranty Service Return ProcedureSerial Number Purchased From Purchase Date Information About Your SystemPage Index Index Page Xantrex Technology Inc