Xantrex Technology Inverter Communications Adapter manual User Interface Features, OFF Srch on CHG

Page 43

User Interface Features

User Interface Features

The ICAP User Interface has the following features. The user can either click on the virtual buttons or use keyboard commands to navigate through the program.

•The ICAP Menu Bar is used for setting ICA parameters (such as number of connected inverters, port usage, customer ID etc.)

•Navigation Buttons are used to navigate through and alter SW Plus Menu Maps.

•Click on these buttons to navigate through the Menu maps.

•Holding your mouse over these buttons will make a keyboard command display. Keyboard commands are also listed starting on page 32 of this manual.

•LEDs and LCD - Displays system status.

•Multiple Unit Drop-Down box - Only appears if ICAP has been set up for multiple ICAs (page 35).

ICAP

EXIT

Menu Bar

01A Inverter

OFF SRCH ON CHG

LCD Display

ButtonsNavigation {

} LEDs

INV/GEN Buttons

Multiple Unit

Menu Heading Buttons

Drop-Down Box

Menu Item Buttons

Set point Buttons

Figure 3-2ICAP User Interface Window

975-0052-01-01 Rev A

27

Image 43

Contents Inverter Communications Adapter ICA Page Inverter Communications Adapter Date and Revision Organization Purpose Scope AudienceIllustrations Conventions UsedAbbreviations and Acronyms Related Information Important Safety Instructions Viii Contents Warranty and Return Information Figures Xii Tables Xiv 1Installation Introduction Features/Components1Inverter Communications Adapter ICA To install the ICA Connecting the ICA Cable2Connecting Directly to the Inverter To use a modem, the following is required Connecting the ICA to a Computer using a ModemTo connect a modem to an inverter 3Connecting the ICA to a Computer using a Modem To connect multiple adapters to a single serial port Connecting Multiple ICAs to a Single Computer4Connecting Multiple ICAs Positive Ground or PV Ground Fault Protection Installations RJ 11 connector on ICA Adapter Advanced Monitoring Software Additional Possible Requirements2Configuration Starting the Setup Program Using Autorun Installing the ICA Software Icap2ICAP License Agreement Screen 4ICAP Install Folder Screen 6Ready to Install Screen 8Installed Screen Starting Setup Manually To start the program from a command prompt Starting Setup From a Command PromptMake a New Connection Setting Up a Modem ConnectionTo establish the type of modem connection Establish the Type of ConnectionTo enter the COM port values Enter COM Port Property ValuesPage 3Operation 1ICAP Splash Screen Starting IcapOFF Srch on CHG User Interface FeaturesExit Icap Menu BarGo Past END Menu To use the Go Past END Menu featureMultiple-Unit Drop-Down Box LEDs and LCD DisplayNavigation Buttons Keyboard Commands 3Keyboard Commands Terminal Emulation Programs Only Changing Icap Settings 3Identifying the Number of ICAs attached Identifying Single or Multiple ICAsTo change ID Number on the ICA Reset to DefaultsAssigning ID Numbers to the ICA Assigning Customer IDs Optional4Assigning ID Numbers to the ICA To make changes to the Advanced Configuration settings Advanced Configuration Settings6Changing the PC’s COM Port Number Changing the PC’s COM Port NumberTroubleshooting the ICA Testing the ICATroubleshooting if No Response comes from the ICA Reset Program Display Anomaly Check Configuration8Screen Display Startup Anomaly #2 Warranty Warranty and Return InformationProduct DisclaimerExclusions Return Material Authorization PolicyOut of Warranty Service Return ProcedureSerial Number Purchased From Purchase Date Information About Your SystemPage Index Index Page Xantrex Technology Inc