Fujitsu 5000 Starting and terminating the ICU For a PC using Windows NT, Set up the resources

■Starting and terminating the ICU (For a PC using Windows NT)

This section explains how to start and terminate the ICU using Windows NT.

1 If the PC is turned on, turn it off.

2 Confirm that the "boot disk" is in write-enable status, insert in the floppy disk drive, then turn on the PC.

MS-DOS is started.

3 Confirm that the "Plug and Play kit for MS-DOS(R) ICU R1.21 disk 1" is in write-enable status, replace the disk with the "boot disk", then enter the following character string and press the [Enter] key:

icu

The ICU is started.

⁄Point

-Do not remove the "Plug and Play kit for MS-DOS(R) ICU R1.21 disk 1" from the floppy disk drive when using the ICU.

-Use the keyboard for all ICU operations.

-Do not set the PCI devices to "Disabled" with the ICU. The devices may not be reset to "Enabled."

4

5

6

Set up the resources.

When resource setup is terminated, terminate the ICU.

Press [Alt]+[F].

The pull-down menu appears.

Select the "Exit" command and press the [Enter] key.

7 Turn off the PC main unit.

30