Converting from the floorstand model to the rack model
The drive cage for the accessible drives is constructed in such a way that the accessible drives and the operating panel module can be taken out simply, tur- ned through 90° to the left, and then be reinstalled.
ÊRemove the dummy covers from the drive cage (figure 15 on page 25).
ÊUnplug the cables from the system board or the accessible drives and remove the drives from the drive cage.
ÊPull the operating panel module forward out of its mounting location until you can pull the the ribbon cable and the USB cable out of the operating panel module. Remove the two cables.
ÊRemove the operating panel module.
ÊTurn the operating panel module through 90° to the left.
Figure 44: Installing the operating panel module
ÊPush the operating panel module halfway into the upper bay of the drive cage.
ÊConnect the ribbon cable and the USB cable to the operating panel module.
ÊNow push the operating panel module fully into the upper bay of the drive cage.
ÊTurn the drives removed beforehand through 90° to the left.
ÊTurn the dummy covers removed beforehand through 90° to the left.
ÊInstall the drives and empty covers in the drive cage.
ÊReestablish all connections to the drives.
56 | Options Guide |