Fujitsu TX150 S3 manual Safety notes Installation and operation

Safety notes

Installation and operation

VCAUTION!

●If the rack model is integrated in an installation that receives power from an industrial (public) power supply network with the IEC309 connector, the (public) power supply protection must comply with the requirements for the non-industrial (public) power supply networks for the type A connector.

●The server automatically sets itself to a voltage in the range of

100 V to 240 V. Make sure that your local voltage is within this range.

●This device has a specially approved power cable and must only be connected to a grounded insulated socket.

●Ensure that the power socket on the device or the grounded wall outlet is freely accessible.

●The ON/OFF button does not disconnect the device from the mains voltage. To disconnect the line voltage completely, remove the power plug(s) from the grounded insulated socket(s).

VCAUTION!

●Always connect the device and the attached peripherals to the same power circuit. Otherwise you run the risk of losing data if, for example, the central processing unit is still running but the peripheral device (e.g. storage subsystem) has failed during a power outage.

●Data cables to peripheral devices must be adequately shielded.

●To the LAN wiring the requirements apply in accordance with the standards EN 50173 and EN 50174-1/2. As minimum requirement the use of a protected LAN line of category 5 for 10/100 MBps Ethernet, and/or of category 5e for Gigabit Ethernet is considered. The requirements of the specification ISO/IEC 11801 are to be considered.

●Route the cables in such a way that they do not form a potential hazard (make sure no-one can trip over them) and that they cannot be damaged. When connecting up a device, refer to the relevant notes in this manual.

●Never connect or disconnect data transmission lines during a storm (lightning hazard).

8 Options Guide U41604-Z156-1-76