Fujitsu fi-4340C manual Contents of the Setup Mode

Contents of the Setup Mode

This section describes the contents of the setup mode.

No	Item	Description	Selectable	Default
			parameters
1		Specifies the double feed detection.
		Double feed is detected by checking the
	Double feed check		No/Yes	No
		document length and/or paper
		thickness.(*1)
2	Length check	Specifies the document length to enable	Tolerance:
		double feed detection sets the document		No
	=No/10/15/20 mm		No/10/15/20mm
		length.
3		Scanner automatically sets the	Document:
			No
		recommended reading parameters. 3 sets
	IPC pre-setting		1: Sharpen	No
		of parameters are available when IPC-4D	2: Darken Character
		is not installed.	3: Copy Quality
4	Resetting of	Resets the abrasion counter.	---	---
	abrasion counter
5	Pick start time	Specifies the time from document Insertion	Time:
		to the start of picking. User can select the		1.0 sec
	setting	most comfortable Pick start time for the job.	0.2 to 29.8 sec
6		Specifies the time the scanner waits for	Time:
	Time-out limit setting	the next document insertion after the last	27 values from	30 sec
		document was scanned.	1 to 1999 sec
7	ADF front offset	Specifies the horizontal and vertical offset	Offset:	Offset:
		of the front side image when using the	H:-2 to +3 mm	H: 0 mm
	setting(*2)
		ADF.	V:-2 to +3 mm	V: 0 mm
8	ADF back offset	Specifies the horizontal and vertical offset	Offset:	Offset:
		of the back side image when using the	H:-2 to +3 mm	H: 0 mm
	setting(*2)
		ADF.	V:-2 to +3 mm	V: 0 mm
9	Document bed	Horizontal and vertical offset of the FB	Offset:	Offset:
			H:-2 to +3 mm	H: 0 mm
	offset setting(*2)	image is specified.
			V:-2 to +3 mm	V: 0 mm
10		Displays whether or not the image
	IPC status display	processing board (IPC-4D) and the	---	---
		Imprinter option are installed.
11	Low Power Mode	Changes the default setting of the duration	5 min.	15 min.
	setting	for power save.	to 60 min.
12	Select Interface	Selects the interface when the scanner	Auto/SCSI/Tps	Auto
		has a board in the third party Slot.
13	Display TPS Board	Displays the ID number of the board which	---	---
	ID Number	is installed in the third party Slot.

●7-3