Messages from the Twain Driver | Fujitsu C150-E187-01EN specs

7.1.1Messages from the TWAIN Driver

∙The input value is outside the range.

Cause:	A value exceeding the range allowed for an input item was input.
User response:	Input a value inside the allowed range. Refer to the input item or the
	image scanner specification for the range.

∙The input value is not acceptable.

Cause:	A value exceeding the range allowed for an input item was input.
User response:	Input a value inside the allowed range. Refer to [Help] of the item or
	the User's Guide for the correct range.

∙This file cannot be removed because it is specified in other side.

Cause:	An attempt was made to remove a file using the dither pattern or
	gamma download pattern file setting dialog. However, the file is
	being used for the other side (front side if back side or back side if
	front side).
User response:	Before removing the file, change the setting of the other side and then
	remove.

∙The initial value data file contains an invalid value. The standard value is set.

Cause:	A value outside the specified range, or invalid text was found in the
	initial-value data file (the specific item involved is indicated by
	Entry=XXXXX). If the file has been modified, the setting value for
	the item may be wrong. If the file has not been rewritten, the file may
	have been damaged.
User response:	The value is set to a standard value. Be sure to check the hard disk
	(chkdsk/scandsk) and check for computer viruses regularly.

∙The value is higher than the maximum scanning size. Either the resolution value or the scanning area has to be reduced.

Cause:	A value exceeding the data capacity of the scanner was specified. As
	the resolution is increased, the amount of data to be scanned also
	increases.
User response:	Decrease the resolution or reduce the size of the scan area.