Fujitsu C150-E187-01EN instruction

∙An input-output error occurred in the image scanner.

Cause:	A fault occured during the scan operation of the image scanner. There
	may be a fault in the image scanner itself.
User response:	Turn off the power of all devices, then turn on the power of the
	computer before turning on the scanner and retry scanning. If the
	error still occurs, contact the retail store where the image scanner was
	purchased, or the nearest service center.

∙Paper jammed in the ADF

Cause:	A paper jam occurred in the device.
User response:	Turn off the power of the device, then remove the paper from inside
	the device. Removing the paper by using excessive force will result
	in device failure, so be careful.

∙The hopper tray is open. Reinsert the document and close the tray.

Cause:	The document tray is open.
User response:	For double-sided scan, close the document tray.

∙No paper in the ADF

Cause:	Although ADF was selected as the paper feeding method, no paper is
	found in the document tray.
User response:	Select another paper feeding method or set the document in the
	document tray.

∙The hopper tray is open, or No paper in the ADF.

Cause:	The hopper tray cover is open, or there is no paper in the ADF.
User response:	Close the hopper tray cover, or load paper.

∙Insufficient buffer memory size of scanner device for current scanning parameters. Please reduce the scanning area or the resolution, or install additional memory in the scanner.

Cause:	A memory option has not been installed in the image scanner.
	Otherwise, a large area or resolution that is not supported by the
	image scanner has been specified.
User response:	Reduce the scanning area or resolution. Otherwise, install the
	memory option. Refer to the User's Guide of the image scanner for
	more information.