Chapter 3 Connecting the Switch
Connecting to the Ethernet Connector Port
Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .
Connecting to the Ethernet Connector Port
Caution To prevent an IP address conflict, do not connect the management port to the network until the initial configuration is complete. For configuration instructions, see the Cisco Nexus 6000 Series CLI Configuration Guide.
This section describes how to connect the Ethernet connector port to an external hub, switch, or router. The Ethernet connector port has an
Step 1 Connect the appropriate modular cable to the Ethernet connector port:
•Use modular,
•Use a
Step 2 Connect the other end of the cable to the device.
Connecting to an Ethernet Port
To connect to an Ethernet port, you must install transceivers and connect them with optical cables.
This section includes the following topics:
•Installing and Replacing Transceivers, page
•Installing Cables into Transceivers, page
Installing and Replacing Transceivers
Caution Excessively removing and installing a transceiver can shorten its life. Unless it is absolutely necessary, do not remove and insert transceivers. To prevent damage to the cable and transceiver, we recommend that you disconnect cables before installing or removing transceivers.
This section includes the following topics:
•Installing a Transceiver, page
•Replacing a Transceiver, page
Installing a Transceiver
To install a transceiver, follow these steps:
Step 1 Attach an
Cisco Nexus 6000 Series Hardware Installation Guide
|
| ||
|
|