Chapter 3 Connecting the Switch
Connecting to an Ethernet Port
Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .
Caution If the cable does not remove easily, ensure that any latch present on the cable has been released before continuing.
To remove the cable, follow these steps:
Step 1 Attach an
Step 2 Press the release latch on the cable, grasp the connector near the connection point, and gently pull the connector from the transceiver.
Step 3 Either install a replacement cable in the transceiver (see the “Installing a Cable into an Transceiver” section on page
Cisco Nexus 6000 Series Hardware Installation Guide
| ||
|