![](/images/new-backgrounds/1142284/14228481x1.webp)
Chapter 4 Replacing Components
Replacing Modules
Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .
Installing a LEM
To install a LEM in a Cisco Nexus 6004 chassis, follow these steps:
Step 1 Insert the LEM into the slot and make sure it is firmly installed.
Step 2 The LEM will auto power on if the poweroff command was not executed earlier on this slot. Otherwise no poweroff module <x> will power it on.
If the following error message is observed, remove and reinsert the LEM as per guidelines:
2013 Feb 21 23:05:17 switch %$
If the error persists beyond 3 attempts, contact customer support.
Replacing Modules
This section includes the following topics:
•Removing a Module, page
•Installing a Module, page
Removing a Module
To remove a module from a Cisco Nexus 6004 chassis, follow these steps:
Step 1 Shut all the ports on the module
Step 2 Poweroff the module using the poweroff module <x> command.
Step 3 Physically remove the module.
Installing a Module
To install a module in a Cisco Nexus 6004 chassis, follow these steps:
Step 1 Insert the module into the slot and make sure it is firmly installed.
Step 2 Power on the moddule using the command no poweroff module <x>
Step 3 Bring up the ports on the module by issuing ‘no shut’ on the interfaces of the module
Cisco Nexus 6000 Series Hardware Installation Guide
|
| ||
|
|