Cisco Systems manual Installing Modules in the Catalyst 6000 Family Switch

Installing the Content Switching Module

Step 4 Loosen the captive installation screws that secure the switching-module filler plate (or an existing switching module) to the desired slot.

Step 5 Remove the switching-module filler plate (or an existing switching module).

Step 6 Hold the handle of the CSM with one hand, and place your other hand under the carrier support. Do not touch the printed circuit boards or connector pins.

Step 7 Place the CSM in the slot. Align the notch on the sides of the switching-module carrier with the groove in the slot. (See Figure 5.)

Figure 5 Installing Modules in the Catalyst 6000 Family Switch

								WS-X6K-SUP1
															100%Switch		Load
															DTE/													PORT 1
						1									DCE																	PORT 2
								SUPERVISOR I					CONSOLE		1%
																					PCMCIA			EJECT
								WS-X6K-SUP1
															100%Switch		Load
						2									DTE/													PORT 1
															DCE																	PORT 2
								SUPERVISOR I					CONSOLE		1%
																					PCMCIA			EJECT
								WS-X6408
											1				2			3			4
						3																			5			6			7			8
								8 PORT GIGABIT ETHERNET
								WS-X6408
						4					1				2			3
																					4				5			6			7
																																		8
								8 PORT GIGABIT ETHERNET
								WS-X6408
											1				2			3			4
						5																			5			6			7			8
								8 PORT GIGABIT ETHERNET
								WS-X6224
						6				1		2	3	4	5	6	7	8	9		10	11	12	13	14	15
																											16	17	18	19	20	21	22	23	24
								24 PORT 100FX
								WS-X6224
						7				1		2	3	4	5	6	7	8
																			9		10	11	12	13	14	15	16
																												17	18	19	20	21	22	23	24
								24 PORT 100FX
								WS-X6224
						8				1		2	3	4	5	6	7	8
																			9		10	11	12	13	14	15	16	17	18	19	20
								24 PORT 100FX																								21	22	23	24
						FAN
						LED
						9
WS-X6224
1	2	3	4	5	6	7	8
								9	10	11	12	13	14		15	16	17
																		18	19	20	21		22	23	24
24 PORT 100FX

o

o

INPUT	FAN OUTPUT		16205
OK	FAIL
	INPUT	FAN OUTPUT
	OK	FAIL

Step 8 Keep the CSM at a 90-degree orientation to the backplane and carefully slide the CSM into the slot until the switching-module faceplate contacts the ejector levers. (See Figure 6.)

	Catalyst 6000 Family Content Switching Module Installation and Configuration Note
14	78-11631-02 Rev. A0