Cisco Systems 6000 manual Front Panel Description, Status LED

Overview

Table 1 Content Switching Module Features (continued)

Feature

Description

Health Monitoring	TCP, HTTP, ICMP, Telnet, FTP
Other Features	SSL session ID, cookie and source IP address-based sticky
	connections
	Fragmented IP frames support
	MTU2 of 9000
	Load and availability reporting supporting remote monitoring and
	management
	High availability preventing service disruptions
	Redundant modules configured for fault-tolerance support

1.SSL = Secure Socket Layer

2.MTU = Maximum Transmission Unit

Front Panel Description

The CSM front panel features are shown in Figure 1.

Figure 1 Content Switching Module Front Panel

CSG

47525

Status	RJ-45 (Test)
LED	connector

Note The RJ-45 connector is covered by a removable plate.

Status LED

When the CSM powers up, it initializes various hardware components and communicates with the supervisor engine. The Status LED on the CSM shows the dialog with the supervisor engine and the results of the initialization.

Note For more information on the supervisor engine LEDs, refer to the Catalyst 6000 Family Module Installation Guide.

During the normal initialization sequence, the status LED changes from Off to Red, Orange, and then Green. Table 2 describes the status LED operation.

	Catalyst 6000 Family Content Switching Module Installation and Configuration Note
4	78-11631-02 Rev. A0