Cisco Systems 6000 manual Writing and Restoring Configurations, Configuring Server NAT

Writing and Restoring Configurations

	Command	Purpose
Step 3
	Router(config-slb-serverfarm)# nat	Associate the configured NAT pool with the
	clientpool-name	server farm.
Step 4
	Router# show ip slb natpool [name pool-name]	Display the NAT configuration.
	[detail]

1.Enter the exit command to leave a mode or submode. Enter the end command to return to the menu’s top level.

2.The no form of this command restores the defaults.

This example shows how to configure client NAT pools:

Router(config)# ip slb natpool pool1 102.36.445.2 102.36.16.8 netmask 255.255.255.0

Router(config)# ip slb serverfarm farm1

Router(config-slb-sfarm)# nat client pool1

Configuring Server NAT

Server NAT allows you to support connections initiated by real servers and to provide a default configuration used for servers initiating connections that do not have matching entries in the server NAT configuration.

To configure NAT for the server, perform this task:

Command	Purpose
Router(config)# ip slb static [drop nat	Configure the server-originated connections.
[ipaddress virtual]]	Options include dropping them, NATing them with a
	given IP address, or NATing them with the virtual IP
	address that they are associated with1, 2.
	Note By default, the CSM allows
	server-originated connections without NAT.

1.Enter the exit command to leave a mode or submode. Enter the end command to return to the menu’s top level.

2.The no form of this command restores the defaults.

Writing and Restoring Configurations

For information about saving and restoring configurations, refer to the Catalyst 6000 Family

IOS Software Configuration Guide.

	Catalyst 6000 Family Content Switching Module Installation and Configuration Note
34	78-11631-02 Rev. A0