Cisco Systems SFS 7012 manual Connect Equipment to the Ports and Power On the System, Leaf

Chapter

Figure 2-9 SFS 7012 Chassis — Spine Module Slot Numbering

b.Leaf Modules— Leaf modules should be populated beginning with slot 1, then slot 2, then slots 3 through 12 respectively. Refer to Figure 2-10:

		Figure 2-10 SFS 7012 Chassis — Leaf Module Slot Numbering
		Leaf 11	Leaf 12
		Leaf 9	Leaf 10
		Leaf 7	Leaf 8
		Leaf 5	Leaf 6
		Leaf 3	Leaf 4
		Leaf 1	Leaf 2
Step 2		To install a module or filler, hold it so that the ejector handles are on the bottom.
Step 3		Pull the handles out to extend them. Slide the module into the appropriate slot of the chassis until it
		makes contact with the backplane. As the module seats in the chassis, the handles will begin to close.
Step 4		Push the handles in to fully close.
	Note	Be sure that all cards are fully inserted in their respective chassis slots, and that the handles are in the
		locked position. This prevents accidental removal, provides proper grounding for the system, and helps
		to seat the bus connectors in the backplane receptacles.

Connect Equipment to the Ports and Power On the System

Note Before performing the tasks in this section, take a few minutes to review Figure 2-11and Figure 2-12below. It is important to understand the slot numbering for the leaf modules and spine modules (and the corresponding spine RJ-45 ports). It is also important to understand the slot numbering for the fans and power supplies (and the corresponding AC power inlets for the power supplies).

Cisco SFS 7012 InfiniBand Server Switch Hardware Users Guide

OL-8787-04 27