Cisco Systems 3750-X, 3560-X manual Entering the Initial Configuration Information, IP Settings

Appendix C Configuring the Switch with the CLI-Based Setup Program

Entering the Initial Configuration Information

Uninstalling the Cisco Microsoft Windows Vista and Windows 7 USB Driver

Note Disconnect the switch console terminal before uninstalling the driver.

Step 1 Run setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next. Step 2 The InstallShield Wizard for Cisco Virtual Com appears. Click Next.

Step 3 When the Program Maintenance window appears, select the Remove radio button. Click Next. Step 4 When the Remove the Program window appears, click Remove.

Note If a User Account Control warning appears, click Allow - I trust this program to proceed.

Step 5 When the InstallShield Wizard Completed window appears click Finish.

Entering the Initial Configuration Information

To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered on. You must assign an IP address and other configuration information necessary for the switch to communicate with the local routers and the Internet. This information is also needed to use the device manager or Cisco Network Assistant to configure and manage the switch.

IP Settings

You need this information from your network administrator:

•Switch IP address

•Subnet mask (IP netmask)

•Default gateway (router)

•Enable secret password

•Enable password

•Telnet password

Configuring the Setup Program

If your switches are stacked and there are multiple console connections to individual switches in the stack, the initial setup dialog appears at the console where you first press Enter.

Completing the setup program and an initial configuration for the switch:

Step 1 Enter Yes at the following two prompts.

Catalyst 3750-X and 3560-X Switch Hardware Installation Guide

C-6 OL-19593-01