Cisco Systems 3750-X, 3560-X manual Table- or Shelf-Mounting

Chapter 2 Switch Installation

Installing the Switch

When you complete the switch installation, see the “After Installing the Switch” section on page 2-21for more information about switch configuration.

Table- or Shelf-Mounting

To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis (See Figure 2-20).

Figure 2-20 Attaching the Adhesive Pads for Table- or Shelf-Mounting

CONSOLE

AUX

STACK 1	RESET
	STACK 2

S-PWR XPS

S-PWR

AC OK
PS	C3
OK
	KX-PWR-
	715WAC

AC OK
PS	C3
OK
	KX-PWR-
	715WAC

253209

1

1

1

Adhesive pads

You can also attach the brackets for a 19-inch rack as shown in Figure 2-21to secure the switch to a shelf or table.

Figure 2-21 Using Brackets for Table- or Shelf-Mounting

MODE
1	2

CONSOLE
SYST	XPS	STAT
EN	S-PWR		SPEED
		MAST			DUPLX
			S	TACK
					PoE

3	4	6
	5		8
		7		10
			9		11	12

13	14	16
	15		17	18
					19	20
							21	22
									23	24

25	26	28
	27		29	30
					31	32
							33	34	35	36

37	38	40
	39		41	42
					43

44	45
Catalyst

46 3750-X

4748

PoE+48

	C3KX-	NM-10G	NETWORK
			MODULE
G1	G2/TE1
		G3	G4/TE2

253403

Caution Do not wall-mount the switch.

When you complete the switch installation, see the “After Installing the Switch” section on page 2-21for more information switch configuration.

	Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
2-20	OL-19593-01