Cisco Systems 3560-X, 3750-X manual Installing SFP and SFP+ Modules, Removing a Network Module

Chapter 2 Switch Installation

Installing SFP and SFP+ Modules

Figure 2-25 Installing the Network Module in the Switch

37	38	4
	39		6
		5		8
			7

	C		NETWORK
	3KX-NM-10G
			MODULE
G1	G2/TE1
		G3	G4/TE2

253156

Caution Do not install the converter module with connected SFP modules or cables. Always remove any cables and modules before installing the converter module in the slot.

Removing a Network Module

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.

Caution Do not remove the network module with installed SFP modules or cables. Always remove any cables and modules before removing the network module from the slot.

Step 2 Disconnect the cables from the SFP module.

Step 3 Remove the SFP modules from the network module.

Step 4 Loosen the captive screws that hold the network module in place.

Step 5 Carefully press the tab on the right side of the network module to release it from the slot. Grasp the edges of the module, and carefully slide it out of the slot.

Step 6 Install a replacement network module or a blank module in the slot.

Step 7 Place the module that you removed in an antistatic bag or other protective environment.

Installing SFP and SFP+ Modules

This section describes how to install and remove SFP modules in the network module.You must have a network module installed in the switch to use SFP modules.

See the “SFP and SFP+ Modules” section on page 1-5and the switch release notes on Cisco.com for the list of SFP modules that the switch supports. Use only Cisco SFP modules on the switch.

For more information about installing, removing, cabling, and troubleshooting SFP modules, see the module documentation that shipped with your device. For module cable specifications, see Appendix B, “Connector and Cable Specifications.”

	Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
OL-19593-01		2-25