
Chapter 2 Switch Installation
Connecting the StackPower Ports to the
Connecting the StackPower Ports to the XPS-2200
Before connecting the StackPower cables, review the “Planning a StackPower Stack (Catalyst
Step 1 Connect the end of the cable with a green stripe to the connector marked XPS on the switch. Align the connector correctly, and insert the end of the cable with a green stripe into an XPS port on the switch rear panel.
Step 2 Connect the end of the cable with a red or yellow stripe to an
Figure 2-24 Connecting the StackPower Cable to an XPS-2200 Port
|
|
| |
|
|
| XPS |
| AUX |
|
|
E |
|
|
|
SOL |
|
| |
CON |
| ET | |
|
| S | |
|
| RES |
|
| STACK | 2 | 9 |
|
| 8 | |
| 1 |
| |
STACK |
| 7 | |
|
| 6 | |
|
| 4 | 5 |
| 3 |
| |
|
|
| |
1 | 2 |
|
|
|
|
|
253672
RESET
Caution Removing and installing the StackPower cable can shorten its useful life. Do not remove and insert the cable more often than necessary.
Installing a Network Module in the Switch
These sections describe how to install and remove
Note There must be a supported network module in the network module slot. If no uplink ports are required, insert a blank network module. An empty slot generates error messages.
The network module is
|
| Catalyst |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
|