Cisco Systems 3750-X, 3560-X manual Installing the DC Power Supply in the Switch

Chapter 3 Power Supply and Fan Module Installation

Installing a DC Power Supply

Step 5 Use the ground screw to attach the single-ground lug to the switch rear panel. Use two ground screws to attach the dual-hole lug to the switch rear panel (Figure 3-10).

Step 6 Using a ratcheting torque screwdriver, torque the ground-lug screws to 60 lbf-in. (960 ozf-in.).

Step 7 Connect the other end of the grounding wire to an appropriate grounding point at your site or to the rack.

Figure 3-10 Attaching the Ground Lug and Wire Assembly

1

CONSOLE

AUX

STACK 1

RESET

STACK 2

2

OLE

AUX

STACK 1

RESET

STACK 2

253161

1

Single-ground screw and lug ring

2

Dual-ground adaptor and dual-hole lug

Installing the DC Power Supply in the Switch

See the Installation Guidelines, page 3-5.

Step 1 Turn off DC power. To ensure that power is off, change the circuit breakers to the OFF position, and tape the circuit-breaker switches in the OFF position.

Step 2 Remove the plastic safety cover from the power supply terminal blocks (Figure 3-4). If you are not replacing a DC power supply, go to Step 5.

Step 3 Use a number-2 Phillips screwdriver to remove the DC-input power wires from the power terminals. Step 4 Press the release latch at the right side of the power supply module inward, and pull the power supply out.

Step 5 Insert the power supply in the power-supply slot, and gently push it into the slot (Figure 3-11). When correctly installed, the DC power supply (excluding the extraction handle) is flush with the switch rear panel.

	Catalyst 3750-X and 3560-X Switch Hardware Installation Guide
3-10	OL-19593-01