
Chapter 2 Switch Installation
Connecting Devices to the Ethernet Ports
Figure 2-27 Network Module with SFP Modules Installed
1 2
37 | 38 | 40 |
|
|
| 39 | 41 | 42 | |
|
|
|
C | NETWORK |
| MODULE |
253157
43 |
44 | 45 |
Catalyst |
46
4748
PoE+48
G2/TE1 | G3 | G4/TE2 |
|
|
34
1 | Network module | 3 | Send (TX) optical bore |
|
|
|
|
|
|
2 | SFP modules | 4 | Receive (RX) optical bore | |
|
|
|
|
|
|
|
|
|
|
Removing an SFP Module
Step 1 Attach an
Step 2 Disconnect the cable from the SFP module. For reattachment, note which cable connector plug is send (TX) and which is receive (RX).
Step 3 Insert a dust plug into the optical ports of the SFP module to keep the optical interfaces clean.
Step 4 If the module has a
Step 5 Grasp the SFP module, and carefully remove it from the module slot.
Step 6 Place the removed SFP module in an antistatic bag or other protective environment.
Connecting Devices to the Ethernet Ports
•10/100/1000 Ethernet Port Connections, page
•PoE+ Port Connections, page
Caution Category 5e and Category 6 cables can store high levels of static electricity. Always ground the cables to a suitable and safe earth ground before connecting them to the switch or other devices.
|
| Catalyst |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
|