Cisco Systems IGX 8400 manual BC-UAI-8-E1 DB-15 Faceplate

Page 33

UXM-E Interface Cards

Table 4-16 Connectors and LEDs for BC-UAI-8-E1 and BC-UAI-4-E1

Connector/Indicator

Function

Eight or four DB-15 connectors

Each DB-15 connector carries transmit and receive data.

 

 

Eight or four pairs of BNC

Each BNC connector carries traffic in one direction.

connectors

 

 

 

 

Red (on the tri-color LED)

On indicates line is active but a local alarm was detected.

 

 

Yellow (on the tri-color LED)

On indicates line is active but a remote alarm was detected.

 

 

Green (on the tri-color LED)

The card is active and in service.

 

 

Figure 4-19

BC-UAI-8-E1 DB-15 Faceplate

UAI-8E1

DB15

R LOC Y REM G OK

P

O

R

T

1

R LOC Y REM G OK

P

O

R

T

2

R LOC Y REM G OK

P

O

R

T

3

R LOC Y REM G OK

P

O

R

T

4

R LOC Y REM G OK

P

O

R

T

5

R LOC Y REM G OK

P

O

R

T

6

R LOC Y REM G OK

P

O

R

T

7

R LOC Y REM G OK

P

O

R

T

8

H11704

RLOC Y REM G OK

P

O

R

T

2

Trunk Cards 4-33

Image 33
Contents Trunk Cards Trunk Front Cards Card Acronym Card Name Trunk Interface CardsTrunk Card Maintenance Trunk Operating ModesLoopback Test Universal Switching Module Enhanced Introduction to the UXM-E Trunk ModeExample Networks with UXM-Es Determining the UXM-E’s Mode of OperationUXM-Es in a Network with Heterogeneous Traffic UXM-E Trunk FeaturesUXM-E Interfaces Back Cards for the UXM-ECard Name Card Description UXM-E Front Card Maximum Number of UXM-Es Switchover to a Redundant UXM-ECabled UXM-E Redundancy UXM-E Status LEDs Fail Active Standby Status of CardCellbus Bandwidth Usage Card MismatchUXM-E as a Clock Source OC3 Planning for Cellbus Bandwidth AllocationATM Across a Public ATM Network Calculating Cellbus Bandwidth ChangesRouting over Cell Trunks Only UXM-E in Trunk ModeTypes of Supported Traffic Traffic from FastPacket-Based Cards Traffic TypeInverse Multiplexing over ATM on IGX Trunks Types of Connections on a UXM-E TrunkAdding an IGX Feeder Line Redundancy Adding and Removing IMA Group LinksTwo-Segment Connections IMA ProtocolRouting Feeder Connection Cell Endpoint a Endpoint B Type Gateway Type Routing Load TypeFeeder Connection Cell Endpoint a Endpoint B Type Three-Segment ConnectionsRT-VBR Gwtypenone ABR.FST GwtypenoneActivation and Configuration of a UXM-E in Trunk Mode UXM-E AtfrOC3 STM1 SMF 20Cisco IGX 8400 Series Reference SCR and PCR Policing at Less than 50 CPS on UXM-E Alarms for Physical Lines and Logical TrunksBXM IGX-UXM-E10 PCR Policing Application Example Trunk Statistics for TroubleshootingUXM-E Interface Cards Summary StatisticsConnectors and LEDs for SMF and MMF Back Cards Connector/Indicator FunctionOC-3/STM1 Back Cards 11 BC-UAI-4-155-SMF Faceplate 12 BC-UAI-2-155-SMF Faceplate T3 Back CardsConnectors and LEDs for BC-UAI-6-T3 and BC-UAI-3-T3 Connectors/Indicator FunctionBC-UAI-6-T3 Faceplate 14 BC-UAI-3-T3 Faceplate E3 Back CardsBC-UAI-6-E3 Faceplate Connectors and LEDs for BC-UAI-6-E3 and BC-UAI-3-E316 BC-UAI-3-E3 Faceplate T1 Back CardsBC-UAI-8-T1-DB-15 Faceplate 18 BC-UAI-4-T1-DB-15 Faceplate E1 Back CardsBC-UAI-8-E1 DB-15 Faceplate Port 21 BC-UAI-4-E1 DB-15 Faceplate 22 BC-UAI-4-E1 BNC Faceplate Cable Redundancy for the NTM NTM StatusNetwork Trunk Module BC-T1 Faceplate Description T1 Interface Card BC-T1BC-T1 Connections and Status LEDs 23 BC-T1 FaceplateE1 Interface Back Card BC-E1 RX-TX BC-E1 Connections and Status LEDsSubrate Interface Card BC-SR BC-SR Connections and Status LEDs Connection/Indicator FunctionY1 Interface Back Card BC-Y1 BC-Y1 Connections and Status LEDs RX MONTX MON 46Cisco IGX 8400 Series Reference