Chapter 1 Catalyst 6500 Series Switch Chassis Overview
Catalyst
Table
Feature | Descriptions |
|
|
Supervisor engines | • Supports Supervisor Engine 2, Supervisor Engine 32, Supervisor |
| Engine 32 PISA, Supervisor Engine 720, Supervisor Engine |
| and Supervisor Engine 2T. |
| – Supervisor Engine 2 is installed in slot 1 and slot 2. |
| – Supervisor Engine 32, Supervisor Engine 32 PISA, Supervisor |
| Engine 720, Supervisor Engine |
| Engine 2T are installed in slot 5 and slot 6. |
| – Supervisor Engine 720, Supervisor Engine |
| Supervisor Engine 2T have |
| Modules |
| supported. |
| – Supervisor Engine 32 and Supervisor Engine 32 PISA do not |
| support the Switch Fabric Modules |
| |
| • The uplink ports are fully functional on the redundant supervisor engine |
| in standby mode. |
| Note In systems with redundant supervisor engines, both supervisor |
| engines must be the same model and have the same daughter card |
| configurations. Each supervisor engine must have the resources to |
| run the switch on its own, which means all supervisor engine |
| resources are duplicated. Identical supervisor engine memory |
| configurations are recommended, but are not required as long as the |
| supervisor engine with the smaller memory configuration is |
| sufficient to run the configured features of the switch. Additionally, |
| each supervisor engine must have its own flash device and console |
| port connections. |
|
|
Modules | • Chassis supports up to five Catalyst 6500 series modules. |
| • |
| installed in slot 5 or slot 6. |
| • Some Catalyst 6500 series modules: |
| – Are not supported |
| – Require that you install a Supervisor Engine 720 |
| – Have chassis slot restrictions |
| – Require a specific software release level |
| Check your software release notes for specific information on module |
| support and restrictions. |
|
|
Catalyst 6500 Series Ethernet Modules Installation Guide
|
| ||
|
|