Chapter 1 Catalyst 6500 Series Switch Chassis Overview
Catalyst 6509 Switch
Table
Feature | Description |
|
|
Supervisor engines | • Supports Supervisor Engine 2, Supervisor Engine 32, Supervisor |
| Engine 32 PISA, Supervisor Engine 720, and Supervisor |
| Engine |
| – Supervisor Engine 2 is installed in slot 1 and slot 2. |
| – Supervisor Engine 32, Supervisor Engine 32 PISA, Supervisor |
| Engine 720, and Supervisor Engine |
| and slot 6. |
| – Supervisor Engine 32, Supervisor Engine 32 PISA, Supervisor |
| Engine 720, and Supervisor Engine |
| |
| a 2500 W or higher capacity power supply in the chassis to power |
| the |
| Note The 2500 W power supply, when supporting the |
| can be powered from either 120 VAC or 220 VAC. |
| – Supervisor Engine 720 and Supervisor Engine |
| |
| and |
| and Supervisor Engine |
| same chassis. |
| – Supervisor Engine 32 and Supervisor Engine 32 PISA do not |
| support the Switch Fabric Modules |
| |
| • The uplink ports are fully functional on all redundant supervisor engine |
| models when they are in standby mode. |
| Note In systems with redundant supervisor engines, both supervisor |
| engines must be the same model and have the same daughter card |
| configurations. Each supervisor engine must have the resources to |
| run the switch on its own, which means all supervisor engine |
| resources are duplicated. Identical supervisor engine memory |
| configurations are recommended, but are not required as long as the |
| supervisor engine with the smaller memory configuration is |
| sufficient to run the configured features of the switch. Additionally, |
| each supervisor engine must have its own flash device and console |
| port connections. |
|
|
Catalyst 6500 Series Ethernet Modules Installation Guide
|
| ||
|
|